Clear All
System of Measurement System of Measurement |
|---|
|
For Shaft Diameter For Shaft Diameter |
|---|
|
For Load Direction For Load Direction |
|---|
 | Combined Radial, Thrust, and Moment |
For Housing ID For Housing ID | Show |
|---|
|
For Housing ID For Housing ID | Hide |
|---|
Maximum Speed Maximum Speed |
|---|
|
OD OD |
|---|
|
ID ID |
|---|
|
Bearing Type Bearing Type |
|---|
 | Roller |
For Shaft Type For Shaft Type |
|---|
 | Round |
Static Combined Load Capacity Static CombinedLoad Capacity |
|---|
|
Dynamic Combined Load Capacity Dynamic CombinedLoad Capacity |
|---|
|
Seal Type Seal Type |
|---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
|---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement)  |
|---|
Maximum Temperature Maximum Temperature |
|---|
|
Minimum Temperature Minimum Temperature |
|---|
|
Roller Bearing Type Roller Bearing Type |
|---|
|
Roller Material Roller Material |
|---|
|
Shaft Mount Type Shaft Mount Type |
|---|
|
Construction Construction |
|---|
|
Ring Material Ring Material |
|---|
|
About Ball and Roller Bearings
More
Crossed-Roller Bearings
With a considerably larger ID than our Face-Mount Crossed-Roller Bearings, use these to run hydraulic lines, electrical wiring, and other components through the inside of the bearing. The rollers face in alternating directions to allow for rigid, accurate motion under any combination of radial, thrust, and moment (twisting) loads. Use in applications where highly accurate motion is necessary, such as machine tools and industrial robots.
Open bearings dissipate heat more efficiently than sealed bearings.
For technical drawings and 3-D models, click on a part number.
Combined Load Cap., lbs. | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
| For Shaft Dia., mm | For Housing ID, mm | Wd., mm | Ring Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Temp. Range, °F | Each | |
Open | ||||||||||
| 20 | 31 | 5 | Steel | 310 | 290 | 2,900 | Required | 0° to 230° | 0000000 | 0000000 |