System of Measurement System of Measurement |
---|
|
For Load Direction For Load Direction |
---|
![]() | Radial |
![]() | Combined Radial, Thrust, and Moment |
For Housing ID For Housing ID | Show |
---|
|
For Housing ID For Housing ID | Hide |
---|
Maximum Speed Maximum Speed |
---|
|
Maximum Temperature Maximum Temperature |
---|
|
Lubrication Lubrication |
---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
---|
Minimum Temperature Minimum Temperature |
---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
---|
|
Seal Type Seal Type |
---|
|
Dynamic Combined Load Capacity Dynamic CombinedLoad Capacity |
---|
|
Roller Material Roller Material |
---|
|
Static Combined Load Capacity Static CombinedLoad Capacity |
---|
|
Construction Construction |
---|
|
For Shaft Type For Shaft Type |
---|
![]() | Round |
Ring Material Ring Material |
---|
|
About Plain Bearings
More
About Ball and Roller Bearings
More
Oil-Embedded Sleeve Bearings

Startup friction causes these porous bronze bearings to release a thin layer of oil on the bearing’s surface. They are also known as Oilite® bearings.
Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.
For technical drawings and 3-D models, click on a part number.
Crossed-Roller Bearings

With a considerably larger ID than our Face-Mount Crossed-Roller Bearings, use these to run hydraulic lines, electrical wiring, and other components through the inside of the bearing. The rollers face in alternating directions to allow for rigid, accurate motion under any combination of radial, thrust, and moment (twisting) loads. Use in applications where highly accurate motion is necessary, such as machine tools and industrial robots.
Open bearings dissipate heat more efficiently than sealed bearings.
For technical drawings and 3-D models, click on a part number.
Combined Load Cap., lbs. | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
For Shaft Dia., mm | For Housing ID, mm | Wd., mm | Ring Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Temp. Range, °F | Each | |
Open | ||||||||||
30 | 41 | 5 | Steel | 390 | 440 | 2,100 | Required | 0° to 230° | 0000000 | 0000000 |