Clear All
System of Measurement System of Measurement |
---|
|
OD OD |
---|
|
ID ID |
---|
|
For Shaft Diameter For Shaft Diameter |
---|
|
For Housing ID For Housing ID | Show |
---|
|
For Housing ID For Housing ID | Hide |
---|
For Load Direction For Load Direction |
---|
![]() | Combined Radial, Thrust, and Moment |
Construction Construction |
---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
---|
Dynamic Combined Load Capacity Dynamic CombinedLoad Capacity |
---|
|
For Shaft Type For Shaft Type |
---|
![]() | Round |
Lubrication Lubrication |
---|
|
Maximum Speed Maximum Speed |
---|
|
Maximum Temperature Maximum Temperature |
---|
|
Minimum Temperature Minimum Temperature |
---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
---|
|
Ring Material Ring Material |
---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
---|
|
Roller Bearing Type Roller Bearing Type |
---|
|
Roller Material Roller Material |
---|
|
Static Combined Load Capacity Static CombinedLoad Capacity |
---|
|
Seal Type Seal Type |
---|
|
Shaft Mount Type Shaft Mount Type |
---|
|
About Ball and Roller Bearings
More
Crossed-Roller Bearings

With a considerably larger ID than our Face-Mount Crossed-Roller Bearings, use these to run hydraulic lines, electrical wiring, and other components through the inside of the bearing. The rollers face in alternating directions to allow for rigid, accurate motion under any combination of radial, thrust, and moment (twisting) loads. Use in applications where highly accurate motion is necessary, such as machine tools and industrial robots.
Open bearings dissipate heat more efficiently than sealed bearings.
For technical drawings and 3-D models, click on a part number.
Combined Load Cap., lbs. | |||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|
For Shaft Dia., mm | For Housing ID, mm | Wd., mm | Ring Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Temp. Range, °F | Features | Each | |
Open | |||||||||||
80 | 91 | 5 | Steel | 680 | 1,200 | 900 | Required | 0° to 175° | Lubrication Hole | 0000000 | 0000000 |