About Ball and Roller Bearings
More
Thin-Profile Crossed-Roller Bearings
For a more compact machine, these bearings have thinner inner and outer rings than high-load crossed-roller bearings. Route hydraulic lines, electrical wiring, and other components through the inside of the bearing. The rollers face in alternating directions to allow for rigid, accurate motion under any combination of radial, thrust, and moment (twisting) loads. Use in applications where highly accurate motion is necessary, such as machine tools and industrial robots.
Sealed bearings block out dust and other contaminants better than open bearings, but retain more heat.
For technical drawings and 3-D models, click on a part number.
Combined Load Cap., lbs. | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| For Shaft Dia., mm | For Housing ID, mm | Wd., mm | Ring Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Temp. Range, °F | Features | Each | |
Sealed | |||||||||||
| 130 | 146 | 8 | Steel | 1,750 | 3,950 | 290 | Lubricated | 0° to 175° | Four Lubrication Holes | 0000000 | 0000000 |
Needle-Roller Thrust Bearings
Thinner rollers allow these bearings to fit in tighter spaces than tapered-roller thrust bearings. Because of the large contact area between the rollers and washers (not included), these bearings are great for medium to heavy duty, low-friction jobs. For use on hardened and ground surfaces.
Washers allow you to use the bearing on unhardened and unground surfaces.
For technical drawings and 3-D models, click on a part number.
Thrust Load Cap., lbs. | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| For Shaft Dia. | OD | Thick. | Dynamic | Static | Max. Speed, rpm | Lubrication | For Shaft Surface Smoothness (Ra), microns | Temp. Range, °F | Specifications Met | Each | |
Steel Rollers | |||||||||||
Open | |||||||||||
| 130mm | 170mm | 5mm | 29,900 | 188,800 | 1,900 | Required | 0.2 | 0° to 240° | DIN 5405-3, ISO 303 | 00000000 | 0000000 |
| For Shaft Dia. | OD | Thick. | Washer Material | Specifications Met | Each | |
| 130mm | 170mm | 1mm | Steel | DIN 5405-3, ISO 303 | 00000000 | 000000 |
Washers for Needle-Roller Thrust Bearings
Adapt needle-roller thrust bearings to use on unhardened, unground surfaces.
For technical drawings and 3-D models, click on a part number.
| For Shaft Dia. | OD | Thick. | Washer Material | Specifications Met | Each | |
| 130mm | 170mm | 1mm | Steel | DIN 5405-3, ISO 303 | 00000000 | 000000 |