We will reply to your message within an hour.
More
Steel balls and washers allow these bearings to handle higher loads than bearings with stainless steel components.
Also known as drawn-cup roller bearings, these are our thinnest roller bearings. The outer ring is drawn out to form a lip that holds the bearing together.
These bearings have higher radial load capacity, speed, and accuracy than standard needle-roller bearings.
The needles in these bearings roll freely in one direction, but lock to transmit torque when the rotation of the shaft is reversed. Also known as drawn-cup roller clutches.
Thinner rollers allow these bearings to fit in tighter spaces than tapered-roller thrust bearings.
Adapt needle-roller thrust bearings to use on unhardened, unground surfaces.
Also known as Oilite® bearings.
Increased iron content makes these bearings stronger and more resistant to shock loads than standard oil-embedded bearings; however they operate at lower speeds.
For applications with frequent starts and stops, the oil in these bearings contains particles of slippery PTFE that lubricate the bearing during startup.
With extra iron and filled with oil containing slippery PTFE, these bearings support heavy loads that frequently start and stop along shafts.
The oil in these bearings is suitable for incidental contact with food.
Embedded with oil that is safe for incidental contact with food, these bearings are suitable for use in high-load applications such as bottling and filling lines in food processing plants. They are also known as Super Oilite® bearings.
Use where high loads and speeds are not required.
Use these bearings in applications with frequent starts and stops because they operate with very little friction.
Made of FDA-listed materials or FDA compliant, these bearings are for use in food applications. They also withstand caustic and washdown environments.
These bronze bearings are strong, wear resistant, and excellent at handling shock loads.
With oil for reduced friction and iron for added strength, these bearings handle frequent stops and starts in high-load applications.
Made of FDA listed materials for use in food applications, these bearings also withstand caustic and washdown environments.
Graphite provides a layer of dry lubrication that operates in high-temperature environments.
These bearings stand up to a wider range of chemicals than other dry-running flanged sleeve bearings.
The oil in these bearings is NSF registered H1 and FDA compliant for incidental contact with food.
Made of 863 iron-copper and embedded with NSF registered H1 oil, these bearings can tackle high-load applications in food plants, such as bottling and filling lines.
A metal backing adds strength.
These nylon bearings swivel inside their housing to compensate for over 20° of shaft misalignment.
Startup friction causes these porous bronze bearings to release a thin layer of oil on the bearing’s surface.
Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.
Also known as Trantorque bushings, these tighten with a twist of the collar nut—no screws needed.
A mounting flange prevents movement during tightening, so it's easy to center these bushings in your sprocket.
The tapered barrel on these bushings is split on both sides, allowing them to contract more tightly around the shaft than quick-disconnect and taper-lock bushings.
Mount these hubless bushings flush into your sprocket or pulley for a slim profile with no protruding screws.