System of Measurement System of Measurement |
|---|
|
For Shaft Diameter For Shaft Diameter | Show |
|---|
|
For Shaft Diameter For Shaft Diameter | Hide |
|---|
Material Material |
|---|
|
ID ID |
|---|
|
OD OD |
|---|
|
Thickness Thickness |
|---|
|
Lubrication Lubrication |
|---|
|
Plain Bearing Type Plain Bearing Type |
|---|
 | Thrust |
Maximum Temperature Maximum Temperature |
|---|
|
For Load Direction For Load Direction |
|---|
 | Thrust |
Bearing Type Bearing Type |
|---|
 | Plain |
Minimum Temperature Minimum Temperature |
|---|
|
Dynamic Thrust Load Capacity Dynamic Thrust Load Capacity |
|---|
|
For Shaft Type For Shaft Type |
|---|
 | Round |
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
|---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement)  |
|---|
Backing Material Backing Material |
|---|
|
Color Color |
|---|
 | Gray |
About Plain Bearings
More
Light Duty Dry-Running Thrust Bearings
Use where high loads and speeds are not required.
Thermoplastic bearings are fiber reinforced and lubricant infused for good wear resistance and low friction with light and medium loads.
Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.
For technical drawings and 3-D models, click on a part number.
| OD | Thick. | Dynamic Thrust Load Capacity | Color | Temperature Range, °F | Each | |
Thermoplastic Blend Bearings | ||||||
|---|---|---|---|---|---|---|
For 26 mm Shaft Dia. | ||||||
| 44mm | 1.5mm | 180 lbs. @ 30 rpm | Gray | -40° to 260° | 0000000 | 00000 |
High-Load Dry-Running Thrust Bearings
A steel backing adds strength to these slippery PTFE bearings.
Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.
For technical drawings and 3-D models, click on a part number.
| OD, mm | Thick., mm | Dynamic Thrust Load Capacity | Temperature Range, °F | Each | |
Steel-Backed PTFE Plastic Bearings | |||||
|---|---|---|---|---|---|
For 26 mm Shaft Dia. | |||||
| 44 | 1.5 | 5,600 lbs. @ 30 rpm | -320° to 530° | 0000000 | 000000 |