Clear All
System of Measurement System of Measurement |
|---|
|
ID ID | Show |
|---|
|
ID ID | Hide |
|---|
For Shaft Diameter For Shaft Diameter |
|---|
|
For Load Direction For Load Direction |
|---|
 | Radial |
Cage Material Cage Material |
|---|
|
Construction Construction |
|---|
|
For Shaft Type For Shaft Type |
|---|
 | Round |
Static Radial Load Capacity Static Radial Load Capacity |
|---|
|
Dynamic Radial Load Capacity Dynamic Radial Load Capacity |
|---|
|
Bearing Type Bearing Type |
|---|
 | Roller |
Seal Type Seal Type |
|---|
|
For Housing ID For Housing ID |
|---|
|
Lubrication Lubrication |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement)  |
|---|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
|---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
|---|
|
For Shaft Surface Smoothness (Ra) For Shaft SurfaceSmoothness (Ra) |
|---|
|
Maximum Temperature Maximum Temperature |
|---|
|
Minimum Temperature Minimum Temperature |
|---|
|
Roller Bearing Type Roller Bearing Type |
|---|
|
Roller Material Roller Material |
|---|
|
About Ball and Roller Bearings
More
Needle-Roller Bearings
Also known as drawn-cup roller bearings, these are our thinnest roller bearings. The outer ring is drawn out to form a lip that holds the bearing together. Bearings take on the shape of their housing and may be oblong prior to installation.
Open bearings dissipate heat more efficiently than sealed bearings.
For technical drawings and 3-D models, click on a part number.
Radial Load Cap., lbs. | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| For Shaft Dia. | For Housing ID | Wd. | Ring Material | Dynamic | Static | Max. Speed, rpm | Lubrication | For Shaft Surface Smoothness (Ra), microinch | Temp. Range, °F | Each | |
Open | |||||||||||
| 3/16" | 11/32" | 3/8" | Steel | 630 | 550 | 21,000 | Required | 8 | -40° to 280° | 00000000 | 000000 |
Shims for Lengthening Screw Shoulders
Spin these shims onto screw threads to extend the shoulder length.
Spring steel shims are harder and hold their shape better than stainless steel shims.
For technical drawings and 3-D models, click on a part number.
1074-1095 Spring Steel
| For Shoulder Dia. | For Screw Size | ID | ID Tolerance | OD | OD Tolerance | Min. Hardness | Magnetic Properties | Pkg. Qty. | Pkg. | |
0.032" Thick. (-0.0015" to 0.0015" Tolerance) | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
| 1/4" | No. 10 | 0.187" | 0" to 0.011" | 0.248" | -0.002" to 0.002" | Rockwell C40 | Magnetic | 25 | 000000000 | 000000 |