Clear All
System of Measurement System of Measurement |
---|
|
For Shaft Diameter For Shaft Diameter |
---|
|
Ball Material Ball Material |
---|
|
For Load Direction For Load Direction |
---|
![]() | Thrust |
OD OD |
---|
|
ID ID | Show |
---|
|
ID ID | Hide |
---|
Bearing Type Bearing Type |
---|
![]() | Ball |
Thickness Thickness |
---|
|
Ball Bearing Type Ball Bearing Type |
---|
![]() | Standard |
Maximum Speed Maximum Speed |
---|
|
Washer Material Washer Material |
---|
|
Cage Material Cage Material |
---|
|
For Shaft Type For Shaft Type |
---|
![]() | Round |
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
---|
|
Static Thrust Load Capacity Static Thrust Load Capacity |
---|
|
Seal Type Seal Type |
---|
|
Lubrication Lubrication |
---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
---|
Maximum Temperature Maximum Temperature |
---|
|
Minimum Temperature Minimum Temperature |
---|
|
About Ball and Roller Bearings
More
Thrust Ball Bearings


Steel balls and washers allow these bearings to handle higher loads than bearings with stainless steel components. With an open design, they dissipate heat more efficiently than one-piece thrust ball bearings.
For technical drawings and 3-D models, click on a part number.
Thrust Load Cap., lbs. | ||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
For Shaft Dia. | OD | Thick. | Cage Material | Washer Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Temp. Range, °F | Includes | Each | |
Open | ||||||||||||
3/16" | 1/2" | 0.193" | Nylon Plastic | Steel | 20 | 120 | 5,000 | Required | -40° to 220° | Two Washers | 0000000 | 00000 |
Corrosion-Resistant Thrust Ball Bearings


A combination of stainless steel and nylon components provide increased corrosion resistance over standard thrust ball bearings. With an open design, they dissipate heat more efficiently than one-piece thrust ball bearings.
For technical drawings and 3-D models, click on a part number.
Thrust Load Cap., lbs. | ||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
For Shaft Dia. | OD | Thick. | Cage Material | Washer Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Temp. Range, °F | Includes | Each | |
Open | ||||||||||||
3/16" | 1/2" | 0.193" | Nylon Plastic | 410 Stainless Steel | 10 | 85 | 5,000 | Required | -40° to 220° | Two Washers | 0000000 | 00000 |