Clear All
System of Measurement System of Measurement |
|---|
|
For Shaft Diameter For Shaft Diameter |
|---|
|
OD OD |
|---|
|
ID ID | Show |
|---|
|
ID ID | Hide |
|---|
Ball Material Ball Material |
|---|
|
For Load Direction For Load Direction |
|---|
 | Thrust |
Bearing Type Bearing Type |
|---|
 | Ball |
Cage Material Cage Material |
|---|
|
Thickness Thickness |
|---|
|
Washer Material Washer Material |
|---|
|
Seal Type Seal Type |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement)  |
|---|
Maximum Temperature Maximum Temperature |
|---|
|
Minimum Temperature Minimum Temperature |
|---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
|---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
|---|
|
Static Thrust Load Capacity Static Thrust Load Capacity |
|---|
|
Lubrication Lubrication |
|---|
|
Maximum Speed Maximum Speed |
|---|
|
For Shaft Type For Shaft Type |
|---|
 | Round |
Ball Bearing Type Ball Bearing Type |
|---|
 | Standard |
About Ball and Roller Bearings
More
Thrust Ball Bearings
Steel balls and washers allow these bearings to handle higher loads than bearings with stainless steel components. With an open design, they dissipate heat more efficiently than one-piece thrust ball bearings.
For technical drawings and 3-D models, click on a part number.
Thrust Load Cap., lbs. | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| For Shaft Dia. | OD | Thick. | Cage Material | Washer Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Temp. Range, °F | Includes | Each | |
Open | ||||||||||||
| 7/16" | 7/8" | 0.249" | Nylon Plastic | Steel | 25 | 190 | 5,000 | Required | -40° to 220° | Two Washers | 0000000 | 00000 |
Corrosion-Resistant Thrust Ball Bearings
A combination of stainless steel and nylon components provide increased corrosion resistance over standard thrust ball bearings. With an open design, they dissipate heat more efficiently than one-piece thrust ball bearings.
For technical drawings and 3-D models, click on a part number.
Thrust Load Cap., lbs. | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| For Shaft Dia. | OD | Thick. | Cage Material | Washer Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Temp. Range, °F | Includes | Each | |
Open | ||||||||||||
| 7/16" | 7/8" | 0.249" | Nylon Plastic | 410 Stainless Steel | 20 | 130 | 5,000 | Required | -40° to 220° | Two Washers | 0000000 | 00000 |