Filter by
System of Measurement
ID
Mounted Bearing Type
Mounting Hole Width
Mounting Hole Center-to-Center
Shaft Mount Type
Alignment Style
Bearing Type
Bearing Seal Type
Number of Set Screws Included
Shaft Type
Housing Material
Lubrication
Material
For Load Direction
Mounting Hole Diameter
Wall Thickness
Shape
DFARS Specialty Metals
About Carbon Steel, Alloy Steel, Spring Steel, and Cast Iron
More
About Ball and Roller Bearings
More
Easy-Align Mounted Ball Bearings with Two-Bolt Flange
An elongated mounting hole on one side of the flange lets you adjust the position of these bearings without having to remove your shaft. You only need to loosen the bolt instead of removing it to adjust. They’re self-aligning to compensate for shaft misalignment.
For technical drawings and 3-D models, click on a part number.
Overall | Mounting | Radial Load Cap., lbs. | |||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| For Shaft Dia. | Ht. | Lg. | Wd. | Flange Thick. | Hole Dia. | Hole Lg. | Hole Ctr.-to-Ctr. | Dynamic | Static | Max. Speed, rpm | Temp. Range, ° F | Alignment Style | Lubrication | Each | |
Sealed Steel Bearings with Cast Iron Housing | |||||||||||||||
Shaft Mount Type: Set Screw | |||||||||||||||
| 5/8" | 2 5/16" | 3 27/32" | 1 1/4" | 7/16" | 25/64" | 1 9/16" | 3 5/64" | 2,850 | 1,450 | 5,500 | 0° to 210° | Self Aligning | Lubricated | 0000000 | 000000 |
Easy-to-Weld 4130 Alloy Steel Round Tubes
- Yield Strength: See table
- Hardness: See table
- Heat Treatable: Yes
- Max. Hardness After Heat Treatment: See table
- Specifications Met: See table
4130 alloy steel has a low carbon content that provides good weldability. It's often used for gears, fasteners, and structural applications. These tubes meet military specifications and SAE dimensional standards.
For technical drawings and 3-D models, click on a part number.
Certificates with a traceable lot number are available for these products. Download certificates from ORDER HISTORY after your order ships.
| OD | OD Tolerance | ID | Yield Strength  | Hardness | Maximum Hardness After Heat Treatment | Specifications Met | Straightness Tolerance | 1 ft. Lg. | 3 ft. Lg. | 6 ft. Lg. | |
0.065" Wall Thick. (-0.01" to 0.01" Tolerance) | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| 3/4" | -0.005" to 0.005" | 0.62" | 70,000 psi | Rockwell C20 | Rockwell C49 | MIL-T-6736, SAE AMS-T-6736, SAE AMS6360 | 0.030" per 3 ft. | 000000000 | |||