Clear All
System of Measurement System of Measurement |
---|
|
For Shaft Diameter For Shaft Diameter |
---|
|
ID ID | Show |
---|
|
ID ID | Hide |
---|
OD OD |
---|
|
Bearing Trade Number Bearing Trade Number |
---|

|
For Load Direction For Load Direction |
---|
![]() | Combined Radial and Thrust |
For Housing ID For Housing ID |
---|
|
Seal Type Seal Type |
---|
|
Maximum Temperature Maximum Temperature |
---|
|
Maximum Speed Maximum Speed |
---|
|
Lubrication Lubrication |
---|
|
Shaft Mount Type Shaft Mount Type |
---|
|
Bearing Type Bearing Type |
---|
![]() | Roller |
Static Radial Load Capacity Static Radial Load Capacity |
---|
|
Dynamic Radial Load Capacity Dynamic Radial Load Capacity |
---|
|
Dynamic Thrust Load Capacity Dynamic Thrust Load Capacity |
---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
---|
Minimum Temperature Minimum Temperature |
---|
|
Cage Width Cage Width |
---|
|
Construction Construction |
---|
|
Inner Ring Width Inner Ring Width |
---|
|
Roller Material Roller Material |
---|
|
About Ball and Roller Bearings
More
Selecting Compatible Lead Screws and Nuts
More
Tapered-Roller Bearings


Found anywhere from machine tool spindles to conveyor rollers, these bearings have a two-piece design that allows for adjustment.
For technical drawings and 3-D models, click on a part number.
Radial Load Cap., lbs. | Thrust Load Cap., lbs. | |||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
For Shaft Dia. | For Housing ID | Wd. | Bearing Trade Number | Dynamic | Static | Dynamic | Static | Max. Speed, rpm | Lubrication | Temp. Range, °F | Each | |
Steel Ring | ||||||||||||
Open | ||||||||||||
63/64" | 1 31/32" | 3/8" | 07097/07196 | 1,550 | 6,650 | 1,050 | 7,750 | 4,100 | Required | -60° to 200° | 0000000 | 000000 |
End Supports for Lead Screws and Ball Screws
A set of ball bearings reduces friction and secures the end of a ball or lead screw. Note: The end of your ball or lead screw must be machined before installing it into an end support.
For technical drawings and 3-D models, click on a part number.
For Combined Radial and Thrust Loads

End supports for combined radial and thrust loads handle radial loads (perpendicular to the lead screw) and thrust loads (parallel to the lead screw).
Combined Load Cap., lbs. | Face Mounting Holes | Top Mounting Holes | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
ID | Ht. | Center Ht. | Wd. | Dp. | Static | Dynamic | No. of Mounting Holes | Dia. | Ctr.-to-Ctr. Wd. | Ctr.-to-Ctr. Ht. | Dia. | Ctr.-to-Ctr. Wd. | Temperature Range, °F | Each | |
Alloy Steel | |||||||||||||||
63/64" | 3 3/8" | 1 3/4" | 6" | 2 29/32" | 3,750 | 2,100 | 6 | 21/32" | 4 1/4" | 2" | 29/32" | 4 1/4" | -40° to 210° | 00000000 | 0000000 |