System of Measurement System of Measurement |
|---|
|
For Shaft Diameter For Shaft Diameter |
|---|
|
ID ID | Show |
|---|
|
ID ID | Hide |
|---|
Plain Bearing Type Plain Bearing Type |
|---|
 | Thrust |
Thickness Thickness |
|---|
|
Bearing Type Bearing Type |
|---|
 | Plain |
For Load Direction For Load Direction |
|---|
 | Thrust |
For Shaft Type For Shaft Type |
|---|
 | Round |
Lubrication Lubrication |
|---|
|
Dynamic Thrust Load Capacity Dynamic Thrust Load Capacity |
|---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
|---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement)  |
|---|
Maximum Temperature Maximum Temperature |
|---|
|
Minimum Temperature Minimum Temperature |
|---|
|
Lubricant Lubricant |
|---|
|
Lubrication Method Lubrication Method |
|---|
|
Shape Shape |
|---|
 | Round Tube |
Wall Thickness Wall Thickness |
|---|
|
Hardness Rating Hardness Rating |
|---|
|
Fabrication Fabrication |
|---|
|
About Plain Bearings
More
About Carbon Steel, Alloy Steel, Spring Steel, and Cast Iron
More
Oil-Embedded Thrust Bearings
Startup friction causes these porous bronze bearings to release a thin layer of oil on the bearing’s surface. They are also known as Oilite® bearings.
Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.
For technical drawings and 3-D models, click on a part number.
| OD | Thick. | Dynamic Thrust Load Capacity | Lubrication | Lubricant | Temperature Range, °F | Each | |
For 1 1/8" Shaft Dia. | |||||||
|---|---|---|---|---|---|---|---|
| 1 7/8" | 1/8" | 3,500 lbs. @ 30 rpm | Lubricated | SAE 30 Oil | -35° to 300° | 00000000 | 00000 |
Easy-to-Weld 4130 Alloy Steel Round Tubes
- Yield Strength: See table
- Hardness: See table
- Heat Treatable: Yes
- Max. Hardness After Heat Treatment: See table
- Specifications Met: See table
4130 alloy steel has a low carbon content that provides good weldability. It's often used for gears, fasteners, and structural applications. These tubes meet military specifications and SAE dimensional standards.
For technical drawings and 3-D models, click on a part number.
Certificates with a traceable lot number are available for these products. Download certificates from ORDER HISTORY after your order ships.
| OD | OD Tolerance | ID | Yield Strength | Hardness | Maximum Hardness After Heat Treatment | Specifications Met | Straightness Tolerance | 1 ft. Lg. | 3 ft. Lg. | 6 ft. Lg. | |
0.12" Wall Thick. (-0.018" to 0.018" Tolerance) | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| 1 3/8" | -0.005" to 0.005" | 1.135" | 70,000 psi | Rockwell C20 | Rockwell C49 | MIL-T-6736, SAE AMS-T-6736, SAE AMS6360 | 0.030" per 3 ft. | 000000000 | |||