49 Products

Increased iron content makes these bearings stronger and more resistant to shock loads than standard oil-embedded bearings; however they operate at lower speeds. Startup friction causes them to release a thin layer of oil on the bearing’s surface. Color is silver because of the iron.

Iron-copper bearings support heavier loads than SAE 863 bronze bearings.

Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.

For technical drawings and 3-D models, click on a part number.

Install these bearings directly onto hardened and ground shafts. They have higher load capacity, speed, and accuracy than standard needle-roller bearings.

Open bearings dissipate heat more efficiently than sealed bearings.

Shaft liners allow you to use the bearing on unhardened and unground shafts.

For technical drawings and 3-D models, click on a part number.

Startup friction causes these porous bronze bearings to release a thin layer of oil on the bearing’s surface. They are self-aligning to compensate for shaft misalignment.

Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.

For technical drawings and 3-D models, click on a part number.

A strong steel housing allows these bearings to handle higher speeds than standard oil-embedded mounted sleeve bearings. Startup friction causes the bearing to release a thin layer of oil on the bearing’s surface.

Bearings with an oil cup have a reservoir that distributes additional oil onto the bearing. A self-closing hinged cover keeps out contaminants.

Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.

For technical drawings and 3-D models, click on a part number.

Startup friction causes these porous bronze bearings to release a thin layer of oil on the bearing’s surface. Bearings are self-aligning to compensate for shaft misalignment.

Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.

For technical drawings and 3-D models, click on a part number.

Bearings are for use with round end-supported shafts. To install, slide bearings into a housing (not included) and secure with two retaining rings (sold individually).

Self Aligning—Bearings compensate for shaft misalignment.

Aluminum bearings have good corrosion resistance. Note: Not for use with bare aluminum, chrome-plated steel, or 300 series stainless steel shafts.

PTFE-lined bearings are chemical resistant and nonabrasive. They have a ceramic coating for added corrosion resistance.

For technical drawings and 3-D models, click on a part number.