24 Products

Install these bearings directly onto hardened and ground shafts. They have higher load capacity, speed, and accuracy than standard needle-roller bearings.

Open bearings dissipate heat more efficiently than sealed bearings.

Shaft liners allow you to use the bearing on unhardened and unground shafts.

For technical drawings and 3-D models, click on a part number.

A strong steel housing allows these bearings to handle higher speeds than standard oil-embedded mounted sleeve bearings. Startup friction causes the bearing to release a thin layer of oil on the bearing’s surface.

Bearings with an oil cup have a reservoir that distributes additional oil onto the bearing. A self-closing hinged cover keeps out contaminants.

Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.

For technical drawings and 3-D models, click on a part number.

Bearings are for use with round end-supported shafts. To install, slide bearings into a housing (not included) and secure with two retaining rings (sold individually).

Self Aligning—Bearings compensate for shaft misalignment.

Bearings with 0.0015" shaft clearance are less likely to bind on your shaft than bearings with 0.0005" shaft clearance.

Aluminum bearings have good corrosion resistance. Note: Not for use with bare aluminum, chrome-plated steel, or 300 series stainless steel shafts.

PTFE-lined bearings are chemical resistant and nonabrasive. They have a ceramic coating for added corrosion resistance.

For technical drawings and 3-D models, click on a part number.

Made of FDA-listed materials for use in food applications, these bearings also have excellent chemical and corrosion resistance. They have a fixed-alignment design for applications where shaft misalignment is unlikely. To install, slide bearings into a housing (not included) and secure with two retaining rings (sold individually).

For technical drawings and 3-D models, click on a part number.