About Ball and Roller Bearings
More
Extra-Clearance Mounted Ball Bearings

Keep shafts, such as those with a shoulder, clear of the mounting surface. These bearings have a higher mounting base that gives them more space to the mounting surface than standard mounting bases. All have a set screw for securing them to shafts without having to use a collar. The screw lets shafts rotate in both directions, so they’re good for applications where you need to reverse.
Overall | Mounting | Radial Load Cap., lbs. | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
For Shaft Dia. | Center Ht. | Ht. | Lg. | Wd. | Hole Lg. | Hole Wd. | Hole Ctr.-to-Ctr. | Dynamic | Static | Max. Speed, rpm | Temp. Range, °F | Alignment Style | Lubrication | Each | |
Sealed Steel Bearings with Cast Iron Housing | |||||||||||||||
Shaft Mount Type: Set Screw | |||||||||||||||
1 9/16" | 3 15/16" | 5 29/32" | 7 1/4" | 2 3/4" | 13/16" | 21/32" | 5 13/32" | 6,500 | 4,000 | 3,000 | 0° to 210° | Self Aligning | Lubricated | 0000000 | 000000 |
Easy-Align Mounted Ball Bearings with Two-Bolt Flange

An elongated mounting hole on one side of the flange lets you adjust the position of these bearings without having to remove your shaft. You only need to loosen the bolt instead of removing it to adjust. They’re self-aligning to compensate for shaft misalignment.
Overall | Mounting | Radial Load Cap., lbs. | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
For Shaft Dia. | Ht. | Lg. | Wd. | Flange Thick. | Hole Dia. | Hole Lg. | Hole Ctr.-to-Ctr. | Dynamic | Static | Max. Speed, rpm | Temp. Range, ° F | Alignment Style | Lubrication | Each | |
Sealed Steel Bearings with Cast Iron Housing | |||||||||||||||
Shaft Mount Type: Set Screw | |||||||||||||||
1 9/16" | 4 1/8" | 6 23/32" | 2" | 9/16" | 33/64" | 2 3/4" | 5 43/64" | 6,500 | 4,000 | 3,000 | 0° to 210° | Self Aligning | Lubricated | 0000000 | 000000 |
Easy-to-Weld 4130 Alloy Steel Round Tubes

- Yield Strength: See table
- Hardness: See table
- Heat Treatable: Yes
- Max. Hardness After Heat Treatment: See table
- Fabrication: Seamless
- Specifications Met: See table
Also known as chrome-moly steel, these 4130 alloy steel round tubes have low carbon content for good weldability. They’re often used for roll cages and frames. To increase their wear resistance, you can harden them with heat treating. These tubes have been manufactured to SAE and military standards for quality and performance.
Certificates with a traceable lot number are available for these products. Download certificates from ORDER HISTORY after your order ships.