Clear All
System of Measurement System of Measurement |
|---|
|
For Shaft Diameter For Shaft Diameter |
|---|
|
Bearing Type Bearing Type |
|---|
 | Roller |
OD OD |
|---|
|
ID ID | Show |
|---|
|
ID ID | Hide |
|---|
For Load Direction For Load Direction |
|---|
 | Thrust |
Static Thrust Load Capacity Static Thrust Load Capacity |
|---|
|
Cage Material Cage Material |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
|---|
Seal Type Seal Type |
|---|
|
For Shaft Surface Smoothness (Ra) For Shaft SurfaceSmoothness (Ra) |
|---|
|
For Shaft Type For Shaft Type |
|---|
 | Round |
Lubrication Lubrication |
|---|
|
Maximum Speed Maximum Speed |
|---|
|
Maximum Temperature Maximum Temperature |
|---|
|
Minimum Temperature Minimum Temperature |
|---|
|
Roller Material Roller Material |
|---|
|
Dynamic Thrust Load Capacity Dynamic ThrustLoad Capacity |
|---|
|
Roller Bearing Type Roller Bearing Type |
|---|
|
Washer Material Washer Material |
|---|
|
About Ball and Roller Bearings
More
Needle-Roller Thrust Bearings
Thinner rollers allow these bearings to fit in tighter spaces than tapered-roller thrust bearings. Because of the large contact area between the rollers and washers (not included), these bearings are great for medium to heavy duty, low-friction jobs. For use on hardened and ground surfaces.
Washers allow you to use the bearing on unhardened and unground surfaces.
For technical drawings and 3-D models, click on a part number.
Bearings
Bearing
Thrust Load Cap., lbs. | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
| For Shaft Dia. | OD | Thick. | Dynamic | Static | Max. Speed, rpm | Lubrication | For Shaft Surface Smoothness (Ra), microns | Temp. Range, °F | Each | |
Steel Rollers | ||||||||||
Open | ||||||||||
| 1 3/4" | 2 1/2" | 5/64" | 5,600 | 30,100 | 4,400 | Required | 0.2 | 0° to 240° | 0000000 | 00000 |
Washers
Washer
| For Shaft Dia. | OD | Thick. | Washer Material | Each | |
| 1 3/4" | 2 1/2" | 0.032" | Steel | 0000000 | 00000 |
Washers for Needle-Roller Thrust Bearings
Washer
Adapt needle-roller thrust bearings to use on unhardened, unground surfaces.
For technical drawings and 3-D models, click on a part number.
| For Shaft Dia. | OD | Thick. | Washer Material | Each | |
| 1 3/4" | 2 1/2" | 0.032" | Steel | 0000000 | 00000 |