A solid polymer lubricant surrounds the balls, eliminating the need for additional lubrication. Because it's solid, the lubricant blocks out water and dust, extending the life of the bearing.

A solid polymer lubricant surrounds the balls, eliminating the need for additional lubrication. Bearings are 440C stainless steel.

Good for applications with incidental food contact, these 440C stainless steel bearings have a food-grade, solid polymer lubricant between the balls and race that eliminates the need for additional lubrication.

Made of slippery plastic, these bearings do not require lubrication and have excellent corrosion and chemical resistance.

These PEEK bearings operate in temperatures almost twice as high as our other plastic ball bearings.

When speed and accuracy matter most, opt for these bearings. They’re made to tighter tolerances than standard flanged ball bearings.

No need to worry about precisely aligning these bearings—they swivel to compensate for up to 5° of shaft misalignment.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

These bearings stand up to a wider range of chemicals than other dry-running sleeve bearings.

Also known as Oilite® bearings.

The needles in these bearings roll freely in one direction, but lock to transmit torque when the rotation of the shaft is reversed. Also known as drawn-cup roller clutches.

Use these bearings for light loads and small shafts. The closed backing blocks out dust and other contaminants.

Made of FDA listed PEEK, these bearings are suitable for direct contact with food. The closed backing blocks out dust and other contaminants.

These internally threaded rod ends have an eyelet and a ball that swivels to support angular misalignment. Also known as rod-end bearings.

Made to extremely tight tolerances, these externally threaded rod ends are for applications that require positioning accuracy, such as accelerators and other types of control linkages.

Larger OD tolerances than standard press-fit bushings allow for finishing. Bushings should be machine ground.

The head prevents these bushings from being pushed through the jig when drilling pressure is extreme. The head sits above the jig plate or can be mounted flush by installing in a counterbored hole.

The serrations grip to prevent rotation and spin out. Press or encase into plastic tooling.

Insert these bushings into a drilled hole and twist the lock ring to secure. Reusable and easy to replace, they are held in in place by a separate locking part.

For a snug fit around a shaft, the ID of these shims is held to a tighter tolerance than other round shims.