Clear All
System of Measurement System of Measurement |
|---|
|
For Shaft Diameter For Shaft Diameter |
|---|
|
Bearing Type Bearing Type |
|---|
 | Ball |
ID ID | Show |
|---|
|
ID ID | Hide |
|---|
Mounted Bearing Type Mounted Bearing Type |
|---|
 | Four-Bolt Flange Mount |
For Load Direction For Load Direction |
|---|
 | Radial |
For Shaft Type For Shaft Type |
|---|
 | Round |
Housing Material Housing Material |
|---|
|
Bearing Material Bearing Material |
|---|
|
Dynamic Radial Load Capacity Dynamic RadialLoad Capacity |
|---|
|
Lubricant Lubricant |
|---|
|
Lubrication Lubrication |
|---|
|
Set Screw Thread Size Set Screw Thread Size |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
|---|
Minimum Temperature Minimum Temperature |
|---|
|
Maximum Temperature Maximum Temperature |
|---|
|
Number of Set Screws Included Number of SetScrews Included |
|---|
|
Flange Thickness Flange Thickness |
|---|
|
Grease Fitting Thread Type Grease Fitting Thread Type |
|---|
|
Misalignment Capability Misalignment Capability |
|---|
|
Mounting Hole Diameter Mounting Hole Diameter |
|---|
|
Mounted Ball Bearings with Four-Bolt Flange
Set Screw Mount
Bearings are self-aligning to compensate for shaft misalignment. Seals block out dust and contaminants.
Set screw bearings secure to shafts as you tighten their screw. They don’t need a collar, but the screw leaves some marring on shafts. Use them in applications where shafts rotate in both directions.
For technical drawings and 3-D models, click on a part number.
Overall | Mounting | Radial Load Cap., lbs. | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| For Shaft Dia. | Ht. | Lg. | Wd. | Flange Thick. | Hole Dia. | Hole Ctr.-to-Ctr. | Dynamic | Static | Max. Speed, rpm | Temp. Range, °F | Alignment Style | Lubrication | Each | |
Sealed Steel Bearings with Cast Iron Housing | ||||||||||||||
Shaft Mount Type: Set Screw | ||||||||||||||
| 2 1/4" | 6 7/8" | 6 7/8" | 2 29/32" | 11/16" | 11/16" | 5 5/8" | 11,800 | 8,100 | 3,400 | -20° to 210° | Self Aligning | Lubricated | 00000000 | 0000000 |
Insert Bearings
Swap out worn inserts instead of replacing the entire mounted unit. Use the manufacturer model number on your existing mounted bearing to choose a compatible insert. Inserts must be used with the manufacturer model number specified.
For technical drawings and 3-D models, click on a part number.
| For Shaft Dia. | For Mounted Bearing Model No. | Each | |
SKF Steel Insert Bearings | |||
|---|---|---|---|
Shaft Mount Type: Set Screw | |||
| 2 1/4" | F4B 204-TF, FY 2.1/4 TF, FYT 2.1/4 TF | 0000000 | 0000000 |