About Plain Bearings
More
About Ball and Roller Bearings
More
About Plastic
More
Needle-Roller Thrust Bearings
Thinner rollers allow these bearings to fit in tighter spaces than tapered-roller thrust bearings. Because of the large contact area between the rollers and washers (not included), these bearings are great for medium to heavy duty, low-friction jobs. For use on hardened and ground surfaces.
Washers allow you to use the bearing on unhardened and unground surfaces.
For technical drawings and 3-D models, click on a part number.
Thrust Load Cap., lbs. | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
| For Shaft Dia. | OD | Thick. | Dynamic | Static | Max. Speed, rpm | Lubrication | For Shaft Surface Smoothness (Ra), microns | Temp. Range, °F | Each | |
Steel Rollers | ||||||||||
Open | ||||||||||
| 3 3/4" | 4 5/8" | 1/8" | 12,600 | 77,400 | 3,500 | Required | 0.2 | 0° to 240° | 00000000 | 000000 |
Oil-Embedded Thrust Bearings
Startup friction causes these porous bronze bearings to release a thin layer of oil on the bearing’s surface. They are also known as Oilite® bearings.
Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.
For technical drawings and 3-D models, click on a part number.
| OD | Thick. | Dynamic Thrust Load Capacity | Lubrication | Lubricant | Temperature Range, °F | Each | |
For 3 3/4" Shaft Dia. | |||||||
|---|---|---|---|---|---|---|---|
| 5" | 1/8" | 10,500 lbs. @ 30 rpm | Lubricated | SAE 30 Oil | -35° to 300° | 00000000 | 000000 |
Clear Scratch- and UV-Resistant Acrylic Tubes
- Color: Clear
- Temperature Range: -40° to 180° F
- Tensile Strength; 9,195-11,030 (Good)
- Impact Strength: 0.040 ft.-lbs./in.
- Hardness: Rockwell M89-M96 (Hard)
- For Use Outdoors: Yes
- Specifications Met: UL 94 HB
When compared to cast acrylic tubes, these extruded acrylic tubes offer nearly the same performance at a fraction of the cost. Use them for sight gauges and protective covers. This scratch- and UV-resistant material stands up to outdoor use better than polycarbonate and maintains clarity over time.
For technical drawings and 3-D models, click on a part number.
| OD | OD Tolerance | ID | ID Tolerance | Lg., ft. | Each | |
1/8" Wall Thick. | ||||||
|---|---|---|---|---|---|---|
| 4" | -0.030" to 0.030" | 3 3/4" | -0.030" to 0.030" | 6 | 0000000 | 000000 |