Clear All
Component Component |
|---|
 | End Support |
System of Measurement System of Measurement |
|---|
|
Width Width |
|---|
|
ID ID | Show |
|---|
|
ID ID | Hide |
|---|
For Load Direction For Load Direction |
|---|
 | Combined Radial and Thrust |
Face Mounting Hole Diameter Face Mounting Hole Diameter |
|---|
|
Top Mounting Hole Diameter Top Mounting Hole Diameter |
|---|
|
Static Combined Load Capacity Static CombinedLoad Capacity |
|---|
|
Bearing Trade Number Bearing Trade Number |
|---|
Number of Mounting Holes Number of Mounting Holes |
|---|
|
Material Material |
|---|
|
Locknut Thread Size Locknut Thread Size |
|---|
|
Dynamic Combined Load Capacity Dynamic CombinedLoad Capacity |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
|---|
Face Mounting Hole Center-to-Center Height Face Mounting HoleCenter-to-Center Height |
|---|
|
Face Mounting Hole Center-to-Center Width Face Mounting HoleCenter-to-Center Width |
|---|
|
Maximum Temperature Maximum Temperature |
|---|
|
Minimum Temperature Minimum Temperature |
|---|
|
Top Mounting Hole Center-to-Center Width Top Mounting HoleCenter-to-Center Width |
|---|
|
Height Height |
|---|
|
Depth Depth |
|---|
|
Selecting Compatible Lead Screws and Nuts
More
End Supports for Lead Screws and Ball Screws
A set of ball bearings reduces friction and secures the end of a ball or lead screw. Note: The end of your ball or lead screw must be machined before installing it into an end support.
For technical drawings and 3-D models, click on a part number.
For Combined Radial and Thrust Loads
End supports for combined radial and thrust loads handle radial loads (perpendicular to the lead screw) and thrust loads (parallel to the lead screw).
Combined Load Cap., lbs. | Face Mounting Holes | Top Mounting Holes | |||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ID | Ht. | Center Ht. | Wd. | Dp. | Static | Dynamic | No. of Mounting Holes | Dia. | Ctr.-to-Ctr. Wd. | Ctr.-to-Ctr. Ht. | Dia. | Ctr.-to-Ctr. Wd. | Temperature Range, °F | Each | |
Alloy Steel | |||||||||||||||
| 43/64" | 2 3/8" | 1 1/4" | 4" | 2 19/64" | 3,200 | 1,550 | 6 | 13/32" | 2 7/8" | 1 3/8" | 17/32" | 2 7/8" | -40° to 210° | 000000000 | 0000000 |