System of Measurement System of Measurement |
---|
|
For Shaft Diameter For Shaft Diameter |
---|
|
ID ID | Show |
---|
|
ID ID | Hide |
---|
OD OD |
---|
|
Bearing Type Bearing Type |
---|
![]() | Plain |
Thickness Thickness |
---|
|
For Load Direction For Load Direction |
---|
![]() | Thrust |
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
---|
|
Color Color |
---|
![]() | Gray |
Dynamic Thrust Load Capacity Dynamic Thrust Load Capacity |
---|
|
Maximum Temperature Maximum Temperature |
---|
|
Minimum Temperature Minimum Temperature |
---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
---|
Lubrication Lubrication |
---|
|
Plain Bearing Type Plain Bearing Type |
---|
![]() | Thrust |
Keyway Depth Keyway Depth |
---|
|
Fastener Tightening Torque Fastener Tightening Torque |
---|
|
Keyway Width Keyway Width |
---|
|
Bushing Type Bushing Type |
---|
|
About Plain Bearings
More
Light Duty Dry-Running Thrust Bearings

Use where high loads and speeds are not required.
Thermoplastic bearings are fiber reinforced and lubricant infused for good wear resistance and low friction with light and medium loads.
Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.
For technical drawings and 3-D models, click on a part number.
OD | Thick. | Dynamic Thrust Load Capacity | Color | Temperature Range, °F | Each | |
Thermoplastic Blend Bearings | ||||||
---|---|---|---|---|---|---|
For 48 mm Shaft Dia. | ||||||
60mm | 2mm | 205 lbs. @ 30 rpm | Gray | -40° to 260° | 0000000 | 00000 |
Quick-Disconnect (QD) Bushings


The screw connections on these bushings easily mate to compatible quick-disconnect sprockets and pulleys. Bushings fit quick-disconnect (QD) sprockets and pulleys of the same bushing style. As you tighten the included screws, the bushing grips the shaft and pulls it into the sprocket or pulley.
For technical drawings and 3-D models, click on a part number.
Keyway | ||||||||
---|---|---|---|---|---|---|---|---|
For Shaft Dia. | Overall Wd. | Wd. | Dp. | Fastener Tightening Torque, in.-lbs. | Material | Includes | Each | |
Clamp On | ||||||||
SK Style Bushing | ||||||||
48mm | 55mm | 14mm | 3.8mm | 180 | Steel | Clamping Screws | 0000000 | 000000 |
Taper-Lock Bushings

Mount these hubless bushings flush into your sprocket or pulley for a slim profile with no protruding screws. They are for use with taper-lock sprockets of the same bushing style. As you tighten the included set screws, the bushing grips the shaft and pulls it into your sprocket or pulley.