McMaster-Carr logo
    Filter by
    System of Measurement
    Shaft Diameter
    Attribute Image
    ID
    Attribute Image
    Material
    Maximum Rotation Speed
    For Housing ID
    Attribute Image
    Bearing Seal Type
    Bearing Type
    Width
    Attribute Image
    Cage Material
    Dynamic Thrust Load Capacity
    Shaft Mount Type
    Bearing Construction
    Ball Bearing Profile
    Static Thrust Load Capacity
    Dynamic Radial Load Capacity
    Shaft Type
    Dynamic Moment Load Capacity
    Maximum Temperature
    Minimum Temperature
    DFARS Specialty Metals
    Export Control Classification Number (ECCN)
    Industrial Info Snippet
    Forward
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Print
    How can we improve?
    Comments
    E-mail address (if you would like a response)
    1 Product

    Four-Point Angular Contact Ball Bearings

    Image of Product. Front orientation. Ball Bearings. Four-Point Angular Contact Ball Bearings.
    Support complex movement in multiple directions with a single compact bearing. The balls distribute weight at four points, so these bearings handle radial, thrust, and moment loads all at once. For example, you’ll often find them in robot arms, which rotate, extend, and twist while supporting an object’s weight. Thinner than two standard angular contact ball bearings paired together, these bearings squeeze into tight spaces. They’re commonly paired with large hollow shafts to run electrical wire and other lines.
    Open—With no rubber seal to block airflow, these bearings dissipate heat quickly, extending the life of the lubricant and reducing friction over time.
    Steel—Strong and wear resistant. However, these bearings are best for dry environments since moisture will cause them to rust.
    ABEC Rating—Bearings with an ABEC rating meet industry tolerance standards established by the Annular Bearing Engineers Committee (ABEC). They're rated on a scale from 1 to 9. The higher the rating, the tighter the tolerance. Bearings rated ABEC 1 or 3 are precise enough for most applications. If your application consistently runs at high speeds or requires high accuracy, consider bearings rated ABEC 5 or higher, since they generate less friction and heat.
    Dynamic
    Load Cap.
    Temp.
    Range, ° F
    For Shaft
    Dia.
    For Housing
    ID
    Wd.
    ABEC
    Rating
    Radial,
    lb.
    Thrust,
    lb.
    Moment,
    ft·lbf
    Max. Rotation
    Speed, rpm
    Contact
    Angle
    Min.
    Max.
    Inner Ring
    Type
    Each
    Open
     
    Steel
    7"7 1/2"1/4"1F1,0001,70023020030°-60250Standard0000000000000000
    Ultra-Thin Ball Bearing, Steel Ring, Open, for 7" Shaft Diameter, 1/4" Wide
    EachDelivers Monday 7-9 am
    Compatible Products for This Ball Bearing
     
    back to top