Clear All
System of Measurement System of Measurement |
|---|
|
For Shaft Diameter For Shaft Diameter |
|---|
|
Bearing Type Bearing Type |
|---|
 | Ball |
OD OD |
|---|
|
ID ID | Show |
|---|
|
ID ID | Hide |
|---|
For Load Direction For Load Direction |
|---|
 | Thrust |
Cage Material Cage Material |
|---|
|
Ball Bearing Type Ball Bearing Type |
|---|
 | Standard |
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
|---|
Dynamic Thrust Load Capacity Dynamic ThrustLoad Capacity |
|---|
|
For Shaft Type For Shaft Type |
|---|
 | Round |
Lubrication Lubrication |
|---|
|
Maximum Speed Maximum Speed |
|---|
|
Maximum Temperature Maximum Temperature |
|---|
|
Minimum Temperature Minimum Temperature |
|---|
|
Static Thrust Load Capacity Static Thrust Load Capacity |
|---|
|
Ball Material Ball Material |
|---|
|
Washer Material Washer Material |
|---|
|
Thickness Thickness |
|---|
|
Seal Type Seal Type |
|---|
|
About Ball and Roller Bearings
More
Thrust Ball Bearings
Steel balls and washers allow these bearings to handle higher loads than bearings with stainless steel components. With an open design, they dissipate heat more efficiently than one-piece thrust ball bearings.
For technical drawings and 3-D models, click on a part number.
Thrust Load Cap., lbs. | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| For Shaft Dia. | OD | Thick. | Cage Material | Washer Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Temp. Range, °F | Includes | Each | |
Open | ||||||||||||
| 7mm | 17mm | 4.92mm | Nylon Plastic | Steel | 15 | 130 | 5,000 | Required | -40° to 220° | Two Washers | 0000000 | 00000 |
Corrosion-Resistant Thrust Ball Bearings
A combination of stainless steel and nylon components provide increased corrosion resistance over standard thrust ball bearings. With an open design, they dissipate heat more efficiently than one-piece thrust ball bearings.
For technical drawings and 3-D models, click on a part number.
Thrust Load Cap., lbs. | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| For Shaft Dia. | OD | Thick. | Cage Material | Washer Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Temp. Range, °F | Includes | Each | |
Open | ||||||||||||
| 7mm | 17mm | 4.92mm | Nylon Plastic | 410 Stainless Steel | 15 | 95 | 5,000 | Required | -40° to 220° | Two Washers | 0000000 | 00000 |