System of Measurement
    System of Measurement
    Inch
    Metric
    For Shaft Diameter
    For Shaft Diameter
    3/8"
    1/2"
    3/4"
    6mm
    8mm
    10mm
    12mm
    20mm
    Travel Distance per Turn
    Travel Distance per Turn
    0.03"
    0.1"
    0.2"
    0.5"
    0.75"
    6mm
    8mm
    10mm
    12mm
    20mm
    Bearing Type
    Bearing Type
    Ball
    Nut Type
    Nut Type
    Threadless
    Material
    Material
    Aluminum
    Component
    Component
    Nut
    Maximum Thrust Capacity Before Slip
    Maximum Thrust
    Capacity Before Slip
    default
    5 lbs.
    15 lbs.
    16 lbs.
    26 lbs.
    30 lbs.
    33 lbs.
    59 lbs.
    60 lbs.
    Mounting Hole Thread Size
    Mounting Hole Thread Size
    6-32
    10-32
    1/4"-20
    M3
    M4
    M5
    M6
    Construction
    Construction
    Two Piece
    Center Height
    Center Height
    default
    37/64"
    49/64"
    1 1/64"
    10mm
    14mm
    18mm
    20mm
    30mm
    Mounting Hole Center-to-Center Length
    Mounting Hole Center-
    to-Center Length
    3/4"
    1"
    1 1/4"
    10mm
    18mm
    20mm
    25mm
    50mm
    Mounting Hole Depth
    Mounting Hole Depth
    1/4"
    3/8"
    1/2"
    6.5mm
    9mm
    12mm
    12.5mm
    Mounting Hole Thread Type
    Mounting Hole Thread Type
    UNC
    UNF
    Metric
    Number of Bearings
    Number of Bearings
    6
    Number of Mounting Holes
    Number of Mounting Holes
    2
    4
    Overall Width
    Overall Width
    default
    1 1/8"
    1 1/2"
    2"
    20mm
    28mm
    36mm
    40mm
    60mm
    Lubrication
    Lubrication
    Lubricated
    Maximum Temperature
    Maximum Temperature
    Less than 250° F
    Minimum Temperature
    Minimum Temperature
    -40° F
    -10° F
    0° F
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    10 Products