Clear All
System of Measurement System of Measurement |
|---|
|
OD OD | Show |
|---|
|
OD OD | Hide |
|---|
Thickness Thickness |
|---|
|
Dynamic Radial Load Capacity Dynamic Radial Load Capacity |
|---|
|
Seal Location Seal Location |
|---|
|
For Load Direction For Load Direction |
|---|
 | Radial |
Bearing Type Bearing Type |
|---|
 | Roller |
Static Radial Load Capacity Static Radial Load Capacity |
|---|
|
Lubrication Lubrication |
|---|
|
Ring Material Ring Material |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement)  |
|---|
Shaft Mount Type Shaft Mount Type |
|---|
|
Cage Material Cage Material |
|---|
|
Maximum Temperature Maximum Temperature |
|---|
|
Minimum Temperature Minimum Temperature |
|---|
|
Maximum Speed Maximum Speed |
|---|
|
For Housing ID For Housing ID |
|---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
|---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
|---|
|
About Ball and Roller Bearings
More
Needle-Roller Bearings
Also known as drawn-cup roller bearings, these are our thinnest roller bearings. The outer ring is drawn out to form a lip that holds the bearing together. Bearings take on the shape of their housing and may be oblong prior to installation.
Open bearings dissipate heat more efficiently than sealed bearings.
Sealed bearings block out dust better than open bearings, but retain more heat.
For technical drawings and 3-D models, click on a part number.
Radial Load Cap., lbs. | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| For Shaft Dia. | For Housing ID | Wd. | Ring Material | Dynamic | Static | Max. Speed, rpm | Lubrication | For Shaft Surface Smoothness (Ra), microinch | Temp. Range, °F | Each | |
Open | |||||||||||
| 1/2" | 11/16" | 3/8" | Steel | 1,040 | 1,200 | 22,000 | Required | 8 | -40° to 280° | 00000000 | 00000 |
Sealed—Both Sides | |||||||||||
| 1/2" | 11/16" | 7/16" | Steel | 1,300 | 1,650 | 22,000 | Lubricated | 8 | -20° to 210° | 00000000 | 00000 |
Washers for Needle-Roller Thrust Bearings
Washer
Adapt needle-roller thrust bearings to use on unhardened, unground surfaces.
For technical drawings and 3-D models, click on a part number.
| For Shaft Dia. | OD | Thick. | Washer Material | Each | |
| 1/4" | 0.687" | 0.095" | Steel | 00000000 | 00000 |