These steel ball bearings handle higher loads than stainless steel and plastic bearings.

Wider than our standard ball bearings, these rugged bearings are good for handling heavy loads at low speeds.

Bearings are 440C stainless steel for good corrosion resistance.

Good for applications with incidental food contact, these 440C stainless steel bearings have a food-grade, solid polymer lubricant between the balls and race that eliminates the need for additional lubrication.

Made of slippery plastic, these bearings do not require lubrication and have excellent corrosion and chemical resistance.

Made of PVDF, these bearings resist moisture absorption, so they won’t warp in underwater applications.

The flange ensures proper positioning inside a tube or housing.

Steel balls and washers allow these bearings to handle higher loads than bearings with stainless steel components.

A metal shell adds strength.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

The addition of iron and aluminum gives these aluminum-bronze bearings high strength and excellent corrosion resistance—making them suitable for use in marine and mining applications.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

Also known as drawn-cup roller bearings, these are our thinnest roller bearings. The outer ring is drawn out to form a lip that holds the bearing together.

Adapt high-precision needle-roller bearings to use on unhardened, unground shafts.

Use ball bearings in debris-free environments and when speed is a necessity. They operate with less friction than sleeve bearings, so you can run them at higher speeds.

Engineered for simultaneous linear and rotary motion, these bearings are used with round end-supported shafts.

Because they usually do not require lubrication, linear sleeve bearings outperform linear ball bearings in dirty environments.

A ceramic liner makes high speeds as well as rapid acceleration and deceleration possible.

These fiberglass bearings are lightweight, nonmagnetic, and won’t conduct electricity.

Designed to handle heavy loads, these bearings have higher load capacities than comparable standard linear ball bearings for support rail shafts.

The flanged housing makes these bearings a good solution for vertical linear motion applications.

Decrease the ID of your rod end to allow approximately 60° of misalignment.

With a diameter that’s held to a close tolerance, this material is hardened for increased wear and abrasion resistance.

Offering excellent antifriction qualities, 932 bronze also offers good strength and wear resistance. It's also known as SAE 660 and is often used for bearings, bushings, and thrust washers.

Thread these one-piece collars onto an Acme lead screw.