McMaster-Carr logo
    Filter by
    Shaft Diameter
    Attribute Image
    Length
    Attribute Image
    OD
    Attribute Image
    Plain Bearing Type
    For Housing ID
    Attribute Image
    Bearing Type
    System of Measurement
    For Load Direction
    Dynamic Radial Load Capacity @ Speed
    DFARS Specialty Metals
    Export Control Classification Number (ECCN)
    Industrial Info Snippet
    Minimum Temperature
    Lubricant
    Lubrication Method
    Shaft Type
    Shaft Mount Type
    Color
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    3 Products

    Oil-Embedded Sleeve Bearings

    Image of Product. Front orientation. Sleeve Bearings. Oil-Embedded Sleeve Bearings.
    Install and forget these self-lubricating bearings. All are made from porous metal and saturated with oil to reduce maintenance and downtime. A good all-around choice, they are used in everything from palm-sized fans in electronics to tire-sized pulleys. Although these bearings will work in most conditions, oil may drip away if temperatures get too high. Consider a graphite-lubricated bearing for higher temperatures or places where you can’t afford the mess. All are fabricated, lubricated, and inspected in the U.S.
    With no moving parts, sleeve bearings are the simplest way to support the load of a rotating shaft while reducing friction. Also known as plain bearings.
    841 Bearing Bronze—A classic choice for a starter pick. Also known as SAE 841 bearings.
    Synthetic Oil Base—A high-quality lubricant makes all the difference. Synthetic oil is less sensitive to temperature changes than mineral oil, so it won't get runny and leak away at higher temperatures. Also known as Oilite® bearings.
    For Shaft
    Dia.
    For Housing
    ID
    Lg.
    Dynamic Radial Load
    Cap. @ Speed
    Base Oil
    Temp. Range,
    ° F
    Each
    841 Bearing Bronze
    1 1/8"1 1/4"1"2,250 lb. @ 30 rpmSynthetic Oil-35 to 3006391K78900000
     

    Dry-Running Sleeve Bearings

    Image of Product. Front orientation. Sleeve Bearings. Dry-Running Sleeve Bearings.
    Made of naturally slippery plastic so you’ll never have to add lubricant. They’re ideal for clean environments where you need to prevent oil drips or graphite flakes. Compared to metal bearings, they are lighter and will never rust.
    With no moving parts, sleeve bearings are the simplest way to support the load of a rotating shaft while reducing friction. Also known as plain bearings.
    High-Strength PEEK—Get the strength of reinforced PTFE without compromising on heat resistance. With no additives, such as polyester fabric, PEEK bearings won’t melt at high temperatures. They’re also nearly as slippery and chemical resistant as plain PTFE.
    Each
    For Shaft
    Dia.
    For Housing
    ID
    Lg.
    Dynamic Radial Load
    Cap. @ Speed
    Color
    Temp. Range,
    ° F
    1-24
    25-99
    100-Up
    High-Strength PEEK
    1"1 1/4"3/4"1,150 lb. @ 60 rpmBlack-40 to 5006621K155000000000000000000
    1"1 1/4"1"1,550 lb. @ 60 rpmBlack-40 to 5006621K156000000000000000
     
    back to top