Use these bearings where high speed and precision are not required.

The flange ensures proper positioning inside a tube or housing.

Steel balls and washers allow these bearings to handle higher loads than bearings with stainless steel components.

With a flexible layer of rubber sandwiched between an oil-embedded bronze bearing and rigid metal shell, these bearings reduce wear and machinery noise.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

Use where high loads and speeds are not required.

Also known as Oilite® bearings.

Increased iron content makes these bearings stronger and more resistant to shock loads than standard oil-embedded bearings; however they operate at lower speeds.

Made of 863 bearing bronze and embedded with NSF registered H1 oil, these bearings can tackle high-load applications in food plants, such as bottling and filling lines.

Graphite provides a layer of dry lubrication that operates in high-temperature environments.

These leaded bronze bearings are strong, wear resistant, and excellent at handling shock loads.

These bearings have higher radial load capacity, speed, and accuracy than standard needle-roller bearings.

Thinner rollers allow these bearings to fit in tighter spaces than tapered-roller thrust bearings.

A ceramic coating makes high speeds as well as rapid acceleration and deceleration possible.

Slide up to two linear ball or sleeve bearings into these housings and secure them with the included internal retaining rings.

A slippery PTFE liner reduces wear and eliminates the need for lubrication.

Stronger than plastic models, these stainless steel swivel joints are also more corrosion resistant than steel joints.

Mount these two-piece collars anywhere on an Acme lead screw without removing components.

Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

Offering excellent antifriction qualities, 932 bronze also offers good strength and wear resistance. It's also known as SAE 660 and is often used for bearings, bushings, and thrust washers.

An excellent alternative to oil-filled bronze, graphite-filled bronze provides dry lubrication in temperatures as high as 700° F.

954 bronze contains a minimum of 10% aluminum for strength and weldability. It is also known as aluminum bronze. It's widely used for bearings, bushings, valve bodies, and worm gears. The strength of this material increases with heat treating.

Be prepared with ring shims in a variety of thicknesses. These shims fit around fasteners and shafts to precisely align, level, and adjust spacing.

These shims are made of layers of metal bonded with adhesive. Remove layers with a utility knife until you get the thickness you need.

Be prepared with shims in a variety of thicknesses. Also known as arbor spacers, these shims are notched to fit over keyed shafts.

Be prepared with shims in a variety of thicknesses. These shims are shaped to fit over D-profile shafts. Use them to precisely align, level, and adjust spacing.

Also known as arbor spacers, these are notched to space components on a keyed shaft.

The head prevents these bushings from being pushed through the jig when drilling pressure is extreme. The head sits above the jig plate or can be mounted flush by installing in a counterbored hole.