A solid polymer lubricant surrounds the balls, eliminating the need for additional lubrication. Because it's solid, the lubricant blocks out water and dust, extending the life of the bearing.

Use these bearings where high speed and precision are not required.

A solid polymer lubricant surrounds the balls, eliminating the need for additional lubrication. Bearings are 440C stainless steel.

These 316 stainless steel bearings are more corrosion resistant than our other stainless steel bearings, but they have a lower load capacity.

With two rows of balls, these lightweight bearings have greater durability and load capacity—and a wider profile—than single-row plastic bearings.

Made of PVDF, these bearings resist moisture absorption, so they won’t warp in underwater applications.

Install these acetal bearings in caustic environments and where lubrication can’t be used. They have good all-around corrosion and chemical resistance.

A combination of stainless steel and nylon components provide increased corrosion resistance over standard thrust ball bearings.

Also known as Oilite® bearings.

Increased iron content makes these bearings stronger and more resistant to shock loads than standard oil-embedded bearings; however they operate at lower speeds.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

Made of FDA listed materials for use in food applications, these bearings also withstand caustic and washdown environments.

These bearings stand up to a wider range of chemicals than other dry-running thrust bearings.

The addition of iron and aluminum gives these aluminum-bronze bearings high strength and excellent corrosion resistance—making them suitable for use in marine and mining applications.

These bearings have higher radial load capacity, speed, and accuracy than standard needle-roller bearings.

4130 alloy steel has a low carbon content that provides good weldability. It's often used for gears, fasteners, and structural applications.

This extruded acrylic offers similar performance as cast acrylic at a lower cost.

Be prepared with ring shims in a variety of thicknesses. These shims fit around fasteners and shafts to precisely align, level, and adjust spacing.

These shims are made of layers of metal bonded with adhesive. Remove layers with a utility knife until you get the thickness you need.

Be prepared with shims in a variety of thicknesses. Also known as arbor spacers, these shims are notched to fit over keyed shafts.

Larger OD tolerances than standard press-fit bushings allow for finishing. Bushings should be machine ground.

The head prevents these bushings from being pushed through the jig when drilling pressure is extreme. The head sits above the jig plate or can be mounted flush by installing in a counterbored hole.