These steel ball bearings handle higher loads than stainless steel and plastic bearings.

A solid polymer lubricant surrounds the balls, eliminating the need for additional lubrication. Bearings are 440C stainless steel.

Good for applications with incidental food contact, these 440C stainless steel bearings have a food-grade, solid polymer lubricant between the balls and race that eliminates the need for additional lubrication.

Made of slippery plastic, these bearings do not require lubrication and have excellent corrosion and chemical resistance.

Steel balls and washers allow these bearings to handle higher loads than bearings with stainless steel components.

Increased iron content makes these bearings stronger and more resistant to shock loads than standard oil-embedded bearings; however they operate at lower speeds.

Use where high loads and speeds are not required.

These bearings stand up to a wider range of chemicals than other dry-running sleeve bearings.

A figure-8-shaped groove provides a flow path for lubricant, distributing it evenly along the bearing’s surface.

With oil for reduced friction and iron for added strength, these bearings handle frequent stops and starts in high-load applications.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

Also known as Oilite® bearings.

Increased iron content makes these bearings stronger and more resistant to shock loads than standard oil-embedded bearings; however they operate at lower speeds.

Handle heavy loads that frequently start and stop along shafts—these bearings contain extra iron and slippery PTFE lubricant. They’re thrust bearings, which means they support loads parallel to the shaft.

These leaded bronze bearings are strong, wear resistant, and excellent at handling shock loads.

Also known as drawn-cup roller bearings, these are our thinnest roller bearings. The outer ring is drawn out to form a lip that holds the bearing together.

Use ball bearings in debris-free environments and when speed is a necessity. They operate with less friction than sleeve bearings, so you can run them at higher speeds.

Designed to handle heavy loads, these bearings have higher load capacities than comparable standard linear ball bearings.

Ridges on the inside of these bearings wipe away dust and debris as the bearing travels on a shaft.

Grooved on the inside, these bearings rotate with your spline shaft as they move loads up and down its length.

Without changing the ID, these inserts handle some misalignment on rod ends.

Precisely align, level, and adjust spacing on fasteners and shafts with these shims.