About Plain Bearings
More
About Rod Ends
More
High-Temperature Dry-Running Thrust Bearings
Graphite provides a layer of dry lubrication that operates in high-temperature environments.
Graphalloy bearings perform at extreme temperatures and under water. They are electrically conductive and wear resistant. They’re also our highest temperature thrust bearings.
Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.
| OD | Thick. | Dynamic Thrust Load Capacity | Temperature Range, °F | Each | |
Graphalloy Bearings | |||||
|---|---|---|---|---|---|
For 2 1/4" Shaft Dia. | |||||
| 3 15/16" | 31/64" | 2,500 lbs. @ 36 rpm | -450° to 750° | 0000000 | 0000000 |
Swivel Joints
Also known as spherical bearings, swivel joints support angular misalignment. Press them into a hole or housing where a ball joint rod end won’t fit. They need to be lubricated when first installed and periodically after that. Apply any type of bearing grease to the ball, and rotate it to work it into the races.
Sealed joints keep grease in and contaminants out.
Extended-Life Swivel Joints
Specially designed lubrication channels and integral seals allow these joints to last up to three times longer than other swivel joints. Also known as spherical bearings, they support angular misalignment. Press into a hole or housing where a ball joint rod end won’t fit. All have seals to keep grease in and contaminants out. Joints come greased and can be lubricated through a hole in the housing without removing the load.
| ID | OD | O'all Thick. | Housing Thick. | Max. Ball Swivel | Static Radial Load Cap., lbs. | Max. Temp., °F | Material | Each | |
| 2 1/2" | 3 15/16" | 2 3/16" | 1 7/8" | 7° | 235,500 | 250° | Bearing Steel | 0000000 | 0000000 |
Hub-Mount Screw-Clamp Bushings
Transfer torque directly from a shaft to a hub. These bushings install over your hub to mount a sprocket, pulley, or gear to a shaft at the same time. Common in industrial gearbox applications, they can also connect a hollow shaft over a solid shaft. As screw-clamp bushings, they're good for shock loads. When you tighten the included clamping screws, the outer rings compress against a sprocket, pulley, or gear in between them, causing the inner rings to tighten around the shaft.
| For Shaft Dia. | OD | Overall Wd. | Max. Torque, in.-lbs. | Fastener Tightening Torque, in.-lbs. | Material | Each | |
| 2 1/8" | 3 15/16" | 1 5/16" | 12,150 | 100 | Zinc-Plated Steel | 0000000 | 0000000 |