440C stainless steel bearings are more corrosion resistant than steel bearings.

Open bearings dissipate heat more efficiently than shielded and sealed bearings.

Shielded bearings block out dust and other contaminants, but do not dissipate heat as efficiently as open bearings.

Bearings with extended inner ring provide additional shaft support.

For technical drawings and 3-D models, click on a part number.

When speed and accuracy matter most, opt for these bearings. They’re made to tighter tolerances than standard flanged ball bearings. All are 440C stainless steel for good corrosion resistance. The flange ensures proper positioning inside a tube or housing.

Open bearings dissipate heat more efficiently than shielded bearings.

Shielded bearings block out dust and other contaminants, but do not dissipate heat as efficiently as open bearings.

For technical drawings and 3-D models, click on a part number.

4130 alloy steel has a low carbon content that provides good weldability. It's often used for gears, fasteners, and structural applications. These tubes meet military specifications and SAE dimensional standards.

For technical drawings and 3-D models, click on a part number.

Certificates with a traceable lot number are available for these products. Download certificates from ORDER HISTORY after your order ships.

Mount flush with jig plates for precise drilling. These bushings can also be used as spacers, shims, and machinery bushings.

Don't see the size you need? Additional sizes are available.

For technical drawings and 3-D models, click on a part number.

Larger OD tolerances than standard press-fit bushings allow finishing. These bushings should be machine ground. Mount flush with jig plates for precise drilling. Drill bushings can also be used as spacers, shims, and machinery bushings.

For technical drawings and 3-D models, click on a part number.

Replace worn bushings and quickly change IDs without needing to repeatedly use a lever press. Instead of pressing bushings in and out of your jig fixture, which can cause damage, these bushings slide in and out of sleeves (sold separately). By swapping in a bushing with a different ID, you can change the size of your bit and still use the same hole in your fixture. All are made to tight dimensional tolerances for consistent, accurate results, even as you change them in and out. They're also known as slip-fixed and renewable bushings.

Choose a sleeve with a length that matches the length of your bushing. To prevent bushings from spinning inside the sleeve as you drill, pair a standard sleeve with a lock screw, or use a locking sleeve.

Lock screws thread into a hole in your jig. The head of the screw fits into a notch on the bushing's head, which keeps the bushing from spinning.

Locking sleeves act as a sleeve and lock screw at the same time. They have a raised flange that fits into the notch on the bushing's head, keeping the bushing in place.

For additional sizes, see Made-to-Order Removable Drill Bushings.

For technical drawings and 3-D models, click on a part number.