System of Measurement System of Measurement |
|---|
|
OD OD | Show |
|---|
|
OD OD | Hide |
|---|
For Housing ID For Housing ID |
|---|
|
Cage Material Cage Material |
|---|
|
Ring Material Ring Material |
|---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
|---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement)  |
|---|
Construction Construction |
|---|
|
For Shaft Surface Smoothness (Ra) For Shaft SurfaceSmoothness (Ra) |
|---|
|
Lubrication Lubrication |
|---|
|
Maximum Temperature Maximum Temperature |
|---|
|
Minimum Temperature Minimum Temperature |
|---|
|
Roller Bearing Type Roller Bearing Type |
|---|
|
Roller Material Roller Material |
|---|
|
Static Radial Load Capacity Static Radial Load Capacity |
|---|
|
Dynamic Radial Load Capacity Dynamic Radial Load Capacity |
|---|
|
Maximum Speed Maximum Speed |
|---|
|
About Rod Ends
More
About Ball and Roller Bearings
More
Precision Needle-Roller Bearings
Install these bearings directly onto hardened and ground shafts. They have higher load capacity, speed, and accuracy than standard needle-roller bearings.
Open bearings dissipate heat more efficiently than sealed bearings.
Shaft liners allow you to use the bearing on unhardened and unground shafts.
For technical drawings and 3-D models, click on a part number.
Ball Joint Rod End Seals
Keep dirt out and lubrication in to extend the life of your rod ends. Seals are Buna-N with a stainless steel washer for corrosion resistance. Use them between the head of your rod end and your fastener.
For technical drawings and 3-D models, click on a part number.
| For Rod End ID | ID | OD | Overall Ht. | Material | Washer Material | Pair | |
| 18mm | 18mm | 33mm | 8mm | Buna-N Rubber | 304 Stainless Steel | 0000000 | 00000 |
Self-Centering Screw-Clamp Bushings
A mounting flange prevents movement during tightening, so it's easy to center these bushings in your sprocket. They are also good for shock loads. When you tighten the included screws, the bushing's inner sleeve contracts onto the shaft and the outer sleeve expands to hold your sprocket, pulley, or gear. They can be mounted on shafts with or without keyways.
For technical drawings and 3-D models, click on a part number.
| For Shaft Dia. | OD | Overall Wd. | Max. Torque, in.-lbs. | Fastener Tightening Torque, in.-lbs. | Material | Includes | Each | |
| 19mm | 33mm | 24mm | 1,050 | 42 | Steel | Clamping Screws | 0000000 | 000000 |