About Plastic
More
About Shaft Couplings
More
932 Bearing Bronze Tubes
- Yield Strength: 18,000 psi
- Hardness: Rockwell B35 (Soft)
- Temper: M07
- Heat Treatable: No
- Specifications Met: ASTM B505
Offering excellent antifriction qualities, 932 bronze also offers good strength and wear resistance. It's also known as SAE 660 and is often used for bearings, bushings, and thrust washers.
Certificates with a traceable lot number are available for these products. Download certificates from ORDER HISTORY after your order ships.
Vibration-Damping Flexible Shaft Couplings
Coupling Shown
Assembled
A flexible tire on these couplings safeguards components on your shafts by reducing vibration and shock.
A complete coupling consists of two hubs, one tire, and two quick-disconnect bushings.
Quick-disconnect bushings are easy to install and remove. Tighten their cap screws to secure them to your shafts. For information on quick-disconnect bushing styles, see Quick-Disconnect (QD) Bushings.
Buna-N Rubber Tires | ||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Iron and Steel Hubs | Misalignment Capability | Quick-Disconnect (QD) Bushings | ||||||||||||||
| O'all Lg. | OD | For Motion Type | Each | Max. Speed, rpm | Max. Torque, in.-lbs. | Parallel | Angular | Axial | Temp. Range, °F | Each | Bushing Style | For Shaft Dia. | Each | |||
| 3 15/16" | 6 1/2" | Continuous | 0000000 | 000000 | 4,000 | 1,800 | 0.125" | 4° | 0.313" | -65° to 180° | 0000000 | 000000 | SH | 0000000 | 000000 | |
MDS-Filled Easy-to-Machine Wear-Resistant Cast Nylon Tubes
- Color: Black
- Maximum Temperature: 230° F
- Tensile Strength: 10,000 psi (Good)
- Impact Strength: 1.4 ft.-lbs./in. (Poor)
- Hardness: Rockwell R110 (Hard)
- For Use Outdoors: Yes
- Specifications Met: ASTM D5989
The addition of MDS gives these tubes exceptional wear resistance along with a self-lubricating surface. They're made of cast nylon 6, making them easier to machine and better electrical insulators than other MDS-filled nylon tubes. Tubes can be used to fabricate pulleys, bushings, and bearings installed in hard-to-reach areas where adding a lubricant would be difficult. The OD is oversized and the ID is undersized to allow for finishing to the sizes listed. This material is comparable to Nylatron and Nycast.