A solid polymer lubricant surrounds the balls, eliminating the need for additional lubrication. Because it's solid, the lubricant blocks out water and dust, extending the life of the bearing.

Use these bearings where high speed and precision are not required.

A solid polymer lubricant surrounds the balls, eliminating the need for additional lubrication. Bearings are 440C stainless steel.

These 316 stainless steel bearings are more corrosion resistant than our other stainless steel bearings, but they have a lower load capacity.

With two rows of balls, these lightweight bearings have greater durability and load capacity—and a wider profile—than single-row plastic bearings.

These PEEK bearings operate in temperatures almost twice as high as our other plastic ball bearings.

Install these acetal bearings in caustic environments and where lubrication can’t be used. They have good all-around corrosion and chemical resistance.

A combination of stainless steel and nylon components provide increased corrosion resistance over standard thrust ball bearings.

A metal shell adds strength.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

Use where high loads and speeds are not required.

Reinforced with polyester fabric, these plastic bearings have load and speed capabilities comparable to metal bearings.

Increased iron content makes these bearings stronger and more resistant to shock loads than standard oil-embedded bearings; however they operate at lower speeds.

These bronze bearings are strong, wear resistant, and excellent at handling shock loads.

Adapt high-precision needle-roller bearings to use on unhardened, unground shafts.

Engineered for simultaneous linear and rotary motion, these bearings are used with round end-supported shafts.

Designed to handle heavy loads, these bearings have higher load capacities than comparable standard linear ball bearings.

Ridges on the inside of these bearings wipe away dust and debris as the bearing travels on a shaft.

Made of FDA-listed materials for use in food applications, these bearings also have excellent chemical and corrosion resistance.

Ball bearings create less friction than sleeve bearings, so they require less force to operate.

Designed to handle heavy loads, these bearings have higher load capacities than comparable standard linear ball bearings for support rail shafts.

Made of FDA-listed materials for use in food applications, these bearings also have excellent chemical and corrosion resistance.

The shell, housing, and balls of these bearings are stainless steel for excellent corrosion resistance.

The Frelon liner on these bearings allows them to stand up to a wider range of chemicals than other flange-mounted linear sleeve bearings.

This extruded acrylic offers similar performance as cast acrylic at a lower cost.

Mount these two-piece collars anywhere on an Acme lead screw without removing components.

Larger OD tolerances than standard press-fit bushings allow for finishing. Bushings should be machine ground.

The head prevents these bushings from being pushed through the jig when drilling pressure is extreme. The head sits above the jig plate or can be mounted flush by installing in a counterbored hole.

The knurls resist force and provide better holding strength than serrations. Encase in plastic tooling.