Meeting IP69K for washdown environments, these mounted ball bearings are used in food, beverage, pharmaceutical, and chemical plants. All have NSF registered H1 lubrication, which is certified for incidental contact with food and is suitable for food and beverage applications. Snap optional covers onto bearings to shield them from moisture. Made of polypropylene, they resist corrosion, won’t absorb water, and are FDA compliant.

Polymer-coated cast iron bearings are also known as tapped-base mounted ball bearings. They require access to the underside of the mounting surface.

Concentric lock bearings have a locking collar to center shafts and secure them better than set screw bearings, so there’s less vibration and noise. To install them, tighten the locking collar’s screw so it grips the inner ring.

For technical drawings and 3-D models, click on a part number.

These bearings are rated IP69K as able to withstand washdown environments such as food, pharmaceutical, and chemical plants. Their fluoropolymer-coated housing is as corrosion resistant as 304 steel and safe for contact with food. The lubrication is NSF registered H1 for incidental contact with food. Because they’re permanently lubricated, these bearings are good for use in hard-to-reach areas or spaces that don’t receive regular maintenance. Also known as tapped base mounted ball bearings, they have threaded holes for fastening through the bottom to secure shafts in tight spaces. Having no mounting bolts on top makes them easier to clean, as well.

Concentric lock shaft mount bearings center and secure shafts in the bearing bore. To install, tighten the single screw on the locking collar around its inner ring on your shaft. By gripping shafts firmly, they reduce vibration in your system for quieter operation.Block 3

For technical drawings and 3-D models, click on a part number.

Permanently lubricated and IP69K certified for washdown environments, these mounted ball bearings are useful for hard-to-reach areas in food, beverage, pharmaceutical, and chemical plants. Mount them using their two-bolt flange. For excellent corrosion resistance and preventing rust caused by salt water, chlorine solutions, and chemicals, their housing is made of 316 stainless steel. All have NSF registered H1 lubrication, which is certified for incidental contact with food and is suitable for food and beverage applications.

Concentric lock bearings have a locking collar to center shafts and secure them better than set screw bearings, so there’s less vibration and noise. Install them by tightening the locking collar’s screw until it presses against the inner ring.

Snap optional covers onto bearings to shield them from moisture. Made of polypropylene, they resist corrosion, don’t absorb water, and are FDA compliant.

For technical drawings and 3-D models, click on a part number.

Bearings are self-aligning to compensate for shaft misalignment. Seals block out dust and contaminants.

Concentric lock bearings enable high running speeds while maintaining low levels of vibration; you must pair them with an adapter sleeve (sold separately). They’re good for applications where shafts rotate in both directions.

For technical drawings and 3-D models, click on a part number.