Lock your bit into the adapter to prevent accidental disengagement. These adapters hold hex-shank bits (also known as insert bits) in powered tools.

Bend these adapters up to 90° to access hard-to-reach fasteners. Use them to hold hex-shank bits (also known as insert bits) in powered tools.

A magnetic ring at the end of the adapter holds flat-head screws in place to ensure good contact between the bit and screw. Use these adapters to hold hex-shank bits (also known as insert bits) in powered tools.

Attach these adapters to square-drive tools.

Use a 4 mm bit in a bit driver that's designed for 1/4" bits.

Insert these adapters into your SDS-drive rotary hammer to use it with hex-shank bits (also known as insert bits).

Mount the magnetic base to walls, cabinets, and other steel surfaces.

Store a variety of sizes and styles of bits and adapters in one compact tray.

Insert a bit into the shaft and a magnet holds it in place.

Operate these tools like a standard bit driver and access hard-reach fasteners with the offset head. Insert a bit and a magnet holds it in place.

The bit holder ratchets so you can drive fasteners when there's little space to move the handle. A magnet or retaining ring secures the bit in the holder.

Also known as ESD-safe bit screwdrivers, the handle drains static away from your application, preventing buildup from electrostatic discharge (ESD) that can damage sensitive equipment.

An insulated handle and shaft protect against shock from accidental contact with live electrical circuits. These tools are tested to 1,000 volts to meet EN 60900 and IEC 60900.

Bits have a different tip at each end and snap into the shaft, which is also a nutdriver.

Use these ceramic-tipped screwdrivers for adjusting sensitive electronic components such as capacitors and resistors. They're completely nonconductive and nonmagnetic so there's no risk of short-circuiting or creating magnetic interference. Remove and replace the shafts to use a different size or drive style.

One end attaches to your SDS-drive rotary hammer, and the other end attaches to a drill chuck so you can perform regular drilling and driving operations with round- and hex-shank drill bits.

These stands hold round-shank drill bits of different sizes. The holes are marked with the bit size and decimal equivalent.

These pouches fit onto most hand-held power drills and impact drivers. They have a magnetic panel on the front that can hold bits and fasteners.

The drawer is divided into labeled compartments.

The compartments are sized to hold two reduced-shank drill bits and are marked with the bit size.

Adjust these extensions to the desired length. They have a quick-change mechanism for fast bit changes.

Tighten the set screws to secure the drill bit in the extension.

SDS-Plus shanks have two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers. These extensions have a quick-change mechanism for fast bit changes.

Fasten differently sized screws with these sets. They save you the effort of switching three separate bits in and out of a power tool, instead letting you flip between a countersinking drill and a screwdriver bit with a single hand.