These adhesives are blended with rubber for better impact and moisture resistance than other instant-bond adhesives. Also known as super glue, these thick gels fill gaps between parts and won't drip on vertical surfaces. Use an accelerator (sold separately) to shorten the time it takes the adhesive to reach full strength.

Dispense adhesives in syringes with a plunger (sold separately).

Dispense adhesives in cartridges with a standard caulk gun.

Certificates with a traceable lot number and product shelf life are available for these products. Download certificates from ORDER HISTORY after your order ships.

These low-friction threadlockers harden slowly, allowing ample time to smoothly adjust multiple large bolts for even clamping. They begin to harden once coated surfaces are threaded together and exposure to air is blocked.

Primer (sold separately) cleans the surface and decreases the time to reach full strength. It is recommended when working with aluminum, stainless steel, and titanium; black-oxide finishes, and cadmium and zinc coatings.

Certificates with a traceable lot number and product shelf life are available for these products. Download certificates from ORDER HISTORY after your order ships.

Made from silicone, these sealants are RTV (room-temperature vulcanizing). They’re non-sagging, so they won't drip from vertical and overhead surfaces.

Elongation and joint compression/expansion tolerance indicate flexibility—the higher the values are, the more joint movement sealants can sustain. Sealants that are good for joining dissimilar materials also work well in environments with wide temperature fluctuation.

These structural sealants combine the mechanical strength of an adhesive with excellent sealing properties and high flexibility. They’re non-sagging, so they won't drip from vertical and overhead surfaces.

Elongation and joint compression/expansion tolerance indicate flexibility—the higher the values are, the more joint movement sealants can sustain. For joints between dissimilar materials and in environments with wide temperature fluctuation, choose a sealant with a higher elongation or joint compression/expansion tolerance. For high-wear applications, choose a harder sealant for the most abrasion resistance.

Repair worn and torn rubber parts. These two-part fillers are self leveling to form a tough, flexible new surface. They're often used with conveyor belts, mill liners, and pumps. The size listed is the combined total of the two parts.

For best results, sand or grind the damaged area to improve adhesion. Brush away loose material. Prepare the surface with cleaner and etching agent (sold separately). Use a dispensing gun and mixer nozzle (not included) to apply the fillers, and smooth with the included plastic spatula.

Encase electronic assemblies in a layer of epoxy for protection from dust, chemicals, moisture, mechanical shock, and vibration. The strongest of the potting compounds, epoxies are rigid and wear resistant. They have excellent chemical and moisture resistance, withstand a wide range of temperatures, and provide excellent electrical insulation. All require a mixer nozzle and gun to dispense.

Loctite® 3336™, ES1001™, ES1902™, and ES2500™ come with a mixer nozzle.

Encase electronic assemblies in a layer of urethane for protection from dust, moisture, chemicals, mechanical shock, and vibration. Urethanes withstand a wide range of temperatures and are the best choice for cold-temperature applications. They have excellent flexibility, good chemical and moisture resistance, and provide good electrical insulation. Use a gun (sold separately) with the included mixer nozzle to dispense.

US2350™ also require a 4:1 plunger (sold separately) to dispense.

Create gaskets that withstand temperatures up to 600° F. Gasket makers are used in place of rubber, cork, and other traditional gasket materials for a form-in-place seal and they make it easy to form irregular-shaped gaskets.