These sheets and bars are precision ground either on all six sides or just on the top and bottom.

MIC6 is cast from a high-strength 7000-series aluminum, then stress relieved to maintain dimensional stability during high-speed machining.

Ready for turning in a lathe, these rods are precision ground and held to a strict straightness tolerance.

These rods are precision ground and held to a strict straightness tolerance, so they’re ready for turning in a lathe.

Precision ground and held to a strict straightness tolerance, these rods are ready for turning in a lathe.

These rods, also known as drill blanks, have an undersized diameter for machining your own jobbers'-length drill bits.

Also known as reamer blanks, these rods are hardened for increased abrasion and impact resistance.

Ready for turning in a lathe, these precision-ground rods have a tight diameter tolerance and are held to a strict straightness tolerance.

These bars are precision ground to a tight thickness tolerance.

Made from powdered metal, M4 tool steel has a consistent microstructure that gives it outstanding resistance to wear and abrasion. It is comparable to CPM Rex M4.

These sheets and bars are precision ground to a tight thickness tolerance.

Precision ground and held to a strict straightness tolerance, these rods are ready for turning in your lathe.

Ready for turning in a lathe, these rods are precision ground to a tight diameter tolerance.

Hardened for increased abrasion and impact resistance, these precision-ground rods have a tight diameter tolerance and are ready for turning in your lathe.

These bars have an oversized thickness, length, and width for finishing to your exact requirements.

The diameter on these rods is precision ground while the straightness is held to a strict tolerance, so they're ready for turning in a lathe.

These W1 bars have lower amounts of alloy elements than other tool steels for excellent machinability.

All set for turning in your lathe, these precision-ground rods are held to a strict straightness tolerance.

An oversized diameter allows for finishing to your exact requirements.

From cookware to chemical-processing equipment, 304 stainless steel is a good all-around choice for a wide range of applications.

Polished to either a brushed or mirror-like finish, this material is often used to fabricate decorative enclosures and industrial workstations.

Widely used for fabricating fittings and fasteners, 303 stainless steel machines quickly without sticking to cutting tools.

Use 430 stainless steel in decorative and light structural applications, rather than outdoors or in extreme temperatures.

The addition of molybdenum gives 316 stainless steel excellent corrosion resistance. Use it in a variety of marine and chemical-processing applications.

One side of these sheets is polished to either a brushed or mirror-like finish.

This material machines faster with less wear on cutting tools than standard 316 stainless steel. It's also called Prodec and Project 70+.

2205 stainless steel resists cracking even when faced with a combination of tensile stress, corrosive chemicals, and heat. Also known as duplex stainless steel, it has twice the strength of 316 stainless steel. Use it for high-pressure applications in caustic environments.