We will reply to your message within an hour.
Made from Grade 8 steel, these screws can be used in high-stress applications, such as valves, pumps, motors, and automotive suspension systems. They are at least 25% stronger than medium-strength steel screws.
Twice as strong as low-strength steel screws, these screws are suitable for fastening most machinery and equipment.
Use these general purpose 18-8 stainless steel screws for a variety of fastening applications. They have good chemical resistance.
More corrosion resistant than 18-8 stainless steel screws, these 316 stainless steel screws have excellent resistance to chemicals and salt water.
The standard for high-strength fastening.
Made from alloy steel, these inch size set screws have a thin edge that digs into hard surfaces for a secure hold.
Grade B7, these threaded rods have a tensile strength about one and a half times stronger than low-strength steel rods. They meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges.
Tighten these threaded rods by turning them to the left; once fastened, they resist loosening from counterclockwise motion. Made from Grade B7 steel, their tensile strength is one and a half times higher than low-strength steel rods.
Comparable to Grade 8 steel, these threaded rods have a tensile strength of 150,000 psi, making them about 25% stronger than medium-strength steel rods.
About half the strength of medium-strength steel threaded rods, use these for light duty hanging, mounting, and fastening.
18-8 stainless steel threaded rods have good chemical resistance.
More corrosion resistant than 18-8 and 410 stainless steel threaded rods, these 316 stainless steel rods have excellent resistance to chemicals and salt water.
Also known as machinery eyebolts.
Also known as nut eyebolts, these are designed for through-hole applications.
Unlike conventional eyebolts, you can rotate the eye 360° to match the angle of your load.
The matte black-oxide finish won't reflect light, allowing the eyebolts to blend into the background.
These eyebolts retain their strength in temperatures as low as -40° F.
Create your own lifting eye by adding an eye nut to a stud or bolt.
Designed for angular lifting, hoist rings resist stresses that would bend or break an eyebolt. They have a lifting ring that pivots 180° front to back to compensate for roll and sway when lifting heavy or unbalanced loads.
The ball bearing on these hoist rings makes it easy to rotate your load even after it’s suspended.
Remove the shackle after lifting while keeping the base installed for future use.
An indicator dot changes from red to black when these hoist rings are properly tightened, eliminating the need for a torque wrench.
Make your old puller work like new by replacing worn forcing screws.