System of Measurement
    System of Measurement
    Inch
    Metric
    Shank Type
    Shank Type
    RoundR8 Taper
    Square
    Cut Direction
    Cut Direction
    Right Hand
    Neutral
    Left Hand
    Material
    Material
    Carbide
    Steel
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    For Tool Bit Shank Diameter
    For Tool Bit Shank Diameter
    3/16"
    1/4"
    5/16"
    3/8"
    1/2"
    5/8"
    3/4"
    Head Diameter
    Head Diameter
    3/4"
    7/8"
    1.06"
    2"
    2 1/2"
    3"
    Material Grade
    Material Grade
    Micrograin
    C6
    C2
    End Cutting Edge Angle
    End Cutting Edge Angle
    default
    38°
    52°
    For Insert Shape
    For Insert Shape
    DiamondTriangle
    Insert Shape
    Insert Shape
    TriangleDiamond
    Side Cutting Edge Angle
    Side Cutting Edge Angle
    default
    25°
    30°
    45°
    -5°
    Back Rake Angle
    Back Rake Angle
    default
    12°
    End Relief Angle
    End Relief Angle
    default
    10°
    Offset Travel
    Offset Travel
    0.75"
    1.25"
    Side Rake Angle
    Side Rake Angle
    default
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    463 Products