The male threads on these brass fittings have a sealant applied for extra protection against leaks. Also known as Class 125 fittings, they are built for use in low-pressure applications.

The polished chrome plating not only has a shiny appearance, but also improves corrosion resistance on these Class 125 fittings.

Not only do these brass fittings have the strength to handle high-pressure applications, the male threads have a sealant applied for extra protection against leaks.

The plating on these brass fittings creates a shiny finish and provides extra protection in corrosive environments. Fittings have the strength to handle high-pressure applications.

When space in your pipe line is limited, choose these miniature fittings that are one inch or less in length.

Also known as instrumentation fittings, these have the most precise threads and the tightest tolerances of all the brass pipe fittings we offer.

Also known as Silbraze fittings.

Also known as instrumentation fittings, these are made to tighter tolerances than standard compression fittings. They are compatible with Parker CPI fittings.

The sleeve in these fittings is rubber instead of metal, so it cushions the tubing and absorbs vibration while creating a tight seal.

The flared end of the fitting nests inside the fitting body, providing extra support to the tubing. Fittings are also known as inverted 45° flared fittings.

Solder these fittings to tubing for a permanent, leak-tight connection. They are also known as sweat fittings.

Choose these metal fittings when you need better durability than our plastic push-to-connect fittings.

A single sleeve (ferrule) compresses the tubing as you tighten the nut on these fittings, creating a strong seal. They are brass for good corrosion resistance.

These compression tube fittings meet Department of Transportation FMVSS 571 safety standards for air brake lines.

The nickel plating on these fittings provides better corrosion resistance than unplated brass fittings.

Use at pressures up to 250 psi.

Use at pressures up to 150 psi.

Made of brass, these fittings have good corrosion resistance.

These brass fittings meet NSF/ANSI Standard 61 for drinking water. They include a nut with a built-in sleeve (ferrule), so there’s no need to remove the nut for assembly.

Made of brass, these fittings withstand frequent washdowns in food-processing applications. They also adhere to NSF/ANSI safety standards, so they’re safe to use with food, beverages, and dairy.