Maximum Torque Maximum Torque |
---|
|
Continuous Torque Continuous Torque |
---|
|
Intermittent Torque Intermittent Torque |
---|
|
Maximum Feed Rate Maximum Feed Rate |
---|
|
Minimum Feed Rate Minimum Feed Rate |
---|
|
Plug these power feeds into standard outlets to convert a milling machine from manual feed to motorized power. Speed is variable so you can make adjustments for material, cutter, and coolant. Install on the X (left/right) or the Y (in/out) motion axis. Feed fits below the table surface for unobstructed workpiece mounting, and a limit switch prevents damage caused by over-travel. Single-lever control engages and disengages as well as starts and stops feeds.
Mounting kits allow you to mount the feed to your milling machine. Mounting kits for electric milling machines replace existing Bridgeport electronic-controlled power table feeds.
Torque, in.-lbs. | ||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
Max. | Intermittent | Continuous | Feed Rate, in./min. | Rapid Traverse Rate, in./min. | Speed Control | Voltage | Current, A | Frequency, Hz | For Max. Milling Machine Power, hp | Features | Each | |
140 | 105 | 90 | 3/4-25 | 35 | Dial | 120V AC | 3 | 50, 60 | 3 | Limit Switch, On/Off Switch, Pilot Light, Protective Breaker | 00000000 | 0000000 |
150 | 120 | 100 | 1/2-35 | 35 | Dial | 120V AC | 3 | 50, 60 | 3 | Limit Switch, On/Off Switch, Pilot Light, Protective Breaker | 00000000 | 000000 |
Each | ||
Actuator Pin | 00000000 | 00000 |
Actuator Switch | 00000000 | 0000 |
Bevel Gear | 00000000 | 00000 |
Bottom Cover | 00000000 | 0000 |
Breaker Switch | 00000000 | 00000 |
Brush | 00000000 | 0000 |
Brush Cap | 00000000 | 000 |
Brush Holder | 00000000 | 0000 |
Gear Clutch | 00000000 | 00000 |
Helical Gear | 00000000 | 00000 |
Limit Switch for 140 in.-Lbs. Max. Torque | 00000000 | 00000 |
Limit Switch for 150 in.-Lbs. Max. Torque | 00000000 | 00000 |
Shim Set | 00000000 | 0000 |