Set at a steeper angle than our other crossover bridges, these bridges require less floor space.

Use these standard crossover bridges to walk over conveyors, machines, and pipes.

Configure these general purpose work platforms to fit your application.

Install these standard work platforms for easy access to elevated areas.

Create catwalks, bridges, gangways, and mezzanines by combining these planks, guardrails, and toeboards.

These scaffolds provide the space and height to complete elevated projects that most work platforms can't reach.

Even if your surface isn't level, your scaffold can be—the end frames on these scaffolds adjust independently so you can set each side at a different height.

These cable ramps handle heavy pedestrian and equipment traffic.

Curve these ramps to route cable around bends and corners in indoor areas with heavy pedestrian and equipment traffic.

Multiple channels let you separate different types of cable and cords.

These cable ramps are strong enough to withstand equipment traffic.

Also known as end trucks, use these trolleys with your own beams to create a crane.

Create your own crane with or without posts. Mount beams to your structural ceiling supports for a post-free crane, to four posts for a traditional crane, or to a combination of ceiling supports and posts to free up some floor space.

These cranes can be rolled into your work area for infrequent lifts and then rolled away to free up space.

Transport hook-mount hoists along a beam.

Fit these trolleys to your beam by turning a threaded rod or knob to adjust width—there's no need to disassemble the trolley for installation. Use them to transport hook-mount hoists along a beam.

Layers of resin and fiberglass strands are molded for bar grating with excellent impact resistance that provides better traction than metal bar grating.

Narrow openings prevent items from falling through this grating and make it easier for carts to roll across.

Secure grating to your support structure.

Narrow openings give this grating a higher load bearing surface than our standard metal bar grating and reduce the chance of something falling through.

An integral toeboard keeps tools and parts from falling off this plank grating and meets OSHA 29 CFR 1910.23 for elevated walkways.

Choose these stair treads for greater durability than metal plank grating stair treads.

These lightweight fiberglass treads are corrosion resistant, nonconductive, and nonmagnetic.

This nosing has an integral anchor for installation in fresh concrete stairs; no additional fasteners required.

Add permanent slip resistance to floors, ramps, stairs, and docks with these solid plates.

Secure grating to your support structure.

Also called No. 10 Western Timber and Victor washers, these have large ODs to prevent screws from sinking into wood. The notches allow you to temporarily secure them with nails to keep them from rotating during installation.

Threads float inside the retainer so you can install a bolt at a slight angle to align with off center parts.

A coil makes a stronger grip than standard hairpin cotter pins to prevent accidental release.

Magnets on the hex nut hold the reamer in place in your tool and prevent it from accidentally falling.

A collar on the shank prevents you from reaming past the cutting edge.

Correct hole misalignment when working in confined spaces. About 2" shorter than standard hole-alignment reamers of similar thicknesses, these reamers give you extra room to move when there’s limited space between you and your workpiece.

Elevate hose off the ground to protect it from damage, and to let water on the floor reach a drain.

With five times the capacity of standard C-clamps, these are the highest capacity clamps we offer.

Turn the handle to tighten these multipurpose tools for strong clamping in nearly any application.