Instead of a shaft, these stepper motors have a lead screw that converts rotational motion to linear motion. Moving in increments smaller than the thickness of a sheet of paper, they're ideal for applications that require fine motion control, such as positioning electrical components on a circuit board. They move in equal steps and hold their position when stationary, so they do not require encoders, sensors, or other position feedback devices. The lead screw is built into the motor, so there are fewer points of failure than systems that use a shaft coupling to connect the lead screw. All are bipolar hybrid stepper motors, which deliver greater torque, precision, and efficiency than other types of stepper motors.

External lead screw stepper motors work similar to a traditional linear motion system; attach the load to the flanged nut, which travels back and forth along the lead screw.

Pass-through lead screw stepper motors give you the most design versatility because there are two ways to move your load: on the motor body or on the ends of the lead screw. The motor moves when the lead screw is fixed or the lead screw moves when the motor body is fixed.

Travel distance per full step determines the control you have over the motor’s positioning. The smaller the measurement, the finer positioning control you have, but the more steps it will take to go the same distance.

Dynamic load capacity is the maximum load a motor can move. If you increase the speed, the dynamic load capacity decreases. Click on a part number and select "Product Detail" to view the load-speed chart and confirm the motor will work for your application.

All motors require a driver and controller (not included).

For technical drawings and 3-D models, click on a part number.

To precisely position loads in automated systems that are frequently rinsed, these stepper motors are IP65 rated to seal out water. Their shaft turns in small, equal increments, similar to the hands of a clock. When the shaft stops, it holds its position even when force is applied to the load. This means you don’t need to configure encoders or sensors to control the position of the load. All are hybrid bipolar stepper motors, so they have more torque, precision, and efficiency than other stepper motors.

Holding torque is the force needed to move the shaft out of position when it’s stationary. When the shaft is in motion, torque generally decreases as speed increases. Use a torque-speed curve to confirm which motor will work for your application. Click on a part number and select “Product Detail” to view the curve for a motor.

These stepper motors require a controller and a driver (not included).

For technical drawings and 3-D models, click on a part number.

Maintain speed automatically. These motors come with a speed control with a feedback sensor that adjusts power to maintain your set speed. They combine the speed control characteristics of permanent magnet brushless DC motors with the convenience of AC power—an integrated inverter means they operate on 120 volts AC.

Motors are rated for continuous duty and mount at any angle. Shaft is keyed and comes with key stock. Use the switch on the speed control to set clockwise or counterclockwise rotation.

All have manual overload protection—an LED on the speed control indicates when the overload protection is triggered; use the switch to reset. Control also has an on/off switch and a speed adjustment knob. Panel mount the control up to 10 feet from the motor—it comes with a 10-ft. cable for connection.

For technical drawings and 3-D models, click on a part number.