Search Results
    Clear All
    Cut Style
    Cut Style
    Show
    Rounded-Edge
    Square
    System of Measurement
    System of Measurement
    Inch
    Number of Flutes
    Number of Flutes
    23
    4
    Material
    Material
    Carbide
    Cobalt Steel
    Shank Diameter
    Shank Diameter
    default
    1/8"
    3/16"
    1/4"
    5/16"
    3/8"
    7/16"
    1/2"
    5/8"
    3/4"
    1"
    Number of Milling Ends
    Number of Milling Ends
    1
    End Mill Type
    End Mill Type
    Center Cutting
    Shank Type
    Shank Type
    Round
    Helix Angle
    Helix Angle
    30°
    35°
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Flute Type
    Flute Type
    Spiral
    Individual/Set
    Individual/Set
    Individual
    Flute Spacing
    Flute Spacing
    Equal
    For Maximum Hardness
    For Maximum Hardness
    Rockwell C62
    Neck Diameter
    Neck Diameter
    0.175"
    0.23"
    0.292"
    0.355"
    0.48"
    0.605"
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)

    137 Products