Clear All
    Flute Type
    Flute Type
    Show
    Intersecting
    System of Measurement
    System of Measurement
    Inch
    Mill Diameter
    Mill Diameter
    default
    1/8"
    5/32"
    3/16"
    1/4"
    5/16"
    3/8"
    1/2"
    Shank Diameter
    Shank Diameter
    default
    1/8"
    3/16"
    1/4"
    5/16"
    3/8"
    1/2"
    Cut Style
    Cut Style
    Square
    Flute Pitch
    Flute Pitch
    Coarse
    Fine
    Number of Flutes
    Number of Flutes
    4
    For Use On
    For Use On
    Hardened Steel
    Steel
    Tool Steel
    Material
    Material
    Carbide
    Number of Milling Ends
    Number of Milling Ends
    1
    Length of Cut
    Length of Cut
    1/2"
    9/16"
    5/8"
    3/4"
    13/16"
    1"
    Helix Angle
    Helix Angle
    15°
    Overall Length
    Overall Length
    1 1/2"
    2"
    2 1/2"
    3"
    Flute Spacing
    Flute Spacing
    Equal
    Shank Type
    Shank Type
    Round
    End Mill Type
    End Mill Type
    Center Cutting
    Individual/Set
    Individual/Set
    Individual
    Finish
    Finish
    Uncoated
    REACH (Registration, Evaluation, Authorization and Restriction of Chemicals)
    REACH (Registration,
    Evaluation, Authorization
    and Restriction of Chemicals)
    REACH Compliant
    RoHS (Restriction of Hazardous Substances)
    RoHS (Restriction of
    Hazardous Substances)
    RoHS Compliant
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    14 Products