Increased iron content makes these bearings stronger and more resistant to shock loads than standard oil-embedded bearings; however they operate at lower speeds.

These bronze bearings are strong, wear resistant, and excellent at handling shock loads.

Increased iron content makes these bearings stronger and more resistant to shock loads than standard oil-embedded bearings; however they operate at lower speeds.

These bronze bearings are strong, wear resistant, and excellent at handling shock loads.

Also known as Oilite® bearings.

The tapered barrel on these bushings is split on both sides, allowing them to contract more tightly around the shaft than quick-disconnect and taper-lock bushings.

A mounting flange prevents movement during tightening, so it's easy to center these bushings in your sprocket.

A toothed slot lets these bushings contract for insertion into the bore of your sprocket or pulley and then expand for a snug fit.

Made of chemical-resistant nylon, these collars are suitable for washdown applications.

Installing and removing a collar is as easy as pushing down and lifting up a clamp lever.

Two knurled sides provide micrometer-like movement for precise width adjustments.

One side of these collars locks down like a standard one-piece shaft collar; the other has a flush face that's flat to 0.0005", which lets you mount the collars on a shaft next to precision bearings, sprockets, and gears.

Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

Make quick adjustments to these shaft collars with a lever on the side.

Tighten the set screw to bite into an unhardened shaft for a secure hold.

Two tapped holes on the face of these collars allow you to fasten them to gears, pulleys, and sprockets.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

When one of your shafts is undersized from wear, oversized from coatings, or uncommonly sized, machine one end of these couplings to fit. They clamp around your shafts for a secure hold that won’t cause damage.

Install and remove these shaft couplings without disconnecting the shafts, motors, and other attached components—they’re made in two pieces so you don’t need to slide them onto shaft ends. They’re also useful when you have limited access to the ends of the shafts.

Support the weight of a motor and transfer torque to another shaft at the same time with these couplings.

Each hub includes a set screw (unless noted), which bites into your shaft to hold the coupling in place.

Safely connect slightly misaligned shafts near food lines—the spider on these couplings contains metal, so it’ll trigger a metal detector if a piece frays off and contaminates your batch.