Install and remove these shaft couplings without disconnecting the shafts, motors, and other attached components—they’re made in two pieces so you don’t need to slide them onto shaft ends. They’re also useful when you have limited access to the ends of the shafts. These couplings clamp onto the shafts, creating a secure hold that won’t mar them. Good for high-torque applications, they have a rigid construction. However, their rigidity means these couplings can only connect shafts that are well aligned.

Aluminum couplings are lightweight, making them useful in precision motion control and servomotor applications.

For technical drawings and 3-D models, click on a part number.

Each hub includes a set screw (unless noted), which bites into your shaft to hold the coupling in place. Also known as Lovejoy® couplings, these three-piece couplings have a spider-shaped cushion between two hubs to reduce shock and handle minor shaft misalignment.

Buna-N spiders provide good vibration damping and chemical resistance. Hytrel spiders provide fair vibration damping and excellent chemical resistance.

For technical drawings and 3-D models, click on a part number.

The thick split spider on these couplings can take on twice as much torque as standard spiders, extending the life of bearings, seals, and motors. They are often used to connect motors to pumps, mixers, large conveyors, and other high-torque equipment. To assemble a complete coupling, you will need two hubs, one split spider, and a split spider cover (all sold separately). They are also known as jaw couplings.

The hubs connect to your shaft with a set screw, which bites into the shaft and holds the hub in place. They are keyed and bored to standard ANSI/AGMA 9002 dimensions and tolerances, which means they fit snugly on standard shaft sizes. Spiders act as a cushion between the two hubs, reducing vibration and compensating for slight shaft misalignment. No need to remove hubs, disconnect shafts, or move equipment to replace worn split spiders—they are split along one side for easy installation and removal. The split spider cover sits on top of the spider to hold it in place, completing the coupling.

These split spiders are all urethane, which holds up to repeated abrasion and is difficult to tear. Spiders with a medium-soft hardness rating are the most common choice for these couplings. Their softness allows them to absorb the most vibration. Spiders with medium hardness rating can handle higher torque than the soft spiders, but are not as good at damping vibration. Spiders with a max. temperature of 350° F hold up better near ovens and other hot equipment.

For technical drawings and 3-D models, click on a part number.

Designed to grip evenly around your shaft, these couplings provide more holding power than set screw couplings without marring the shaft. Tighten the clamping screws to secure. Good for precision motor and pump applications, the spider-shaped cushion reduces shock and compensates for minor shaft misalignment. Couplings allow zero backlash (no play).

A complete coupling consists of two hubs and one spider (each component sold separately). Hubs are lightweight, corrosion-resistant aluminum. Spiders are polyurethane for fair vibration damping and good chemical resistance.

For technical drawings and 3-D models, click on a part number.

The included set screw holds the coupling in place. Good for precision motor and pump applications, the spider-shaped cushion reduces shock and compensates for minor shaft misalignment. Couplings allow zero backlash (no play).

A complete coupling consists of two hubs and one spider (each component sold separately). Spiders are polyurethane for fair vibration damping and good chemical resistance.

Nylon hubs are electrically insulating, corrosion resistant, and lightweight. They also are slightly more forgiving of misalignment than aluminum hubs.

Aluminum hubs have good corrosion resistance and are lightweight, though not as lightweight as nylon hubs.

For technical drawings and 3-D models, click on a part number.