Also known as Oilite® bearings.

For applications with frequent starts and stops, the oil in these bearings contains particles of slippery PTFE that lubricate the bearing during startup.

With oil for reduced friction and iron for added strength, these bearings handle frequent stops and starts in high-load applications.

Use where high loads and speeds are not required.

Made of FDA listed materials for use in food applications, these bearings also withstand caustic and washdown environments.

These bearings stand up to a wider range of chemicals than other dry-running flanged sleeve bearings.

Also known as Oilite® bearings.

For applications with frequent starts and stops, the oil in these bearings contains particles of slippery PTFE that lubricate the bearing during startup.

Unlike other sleeve bearings, these do not need to be fully inserted into a housing. Their unique shape creates a permanent, secure hold in thin panels.

Embedded with oil that is safe for incidental contact with food, these bearings are suitable for use in high-load applications such as bottling and filling lines in food processing plants. They are also known as Super Oilite® bearings.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

Permanently and securely install these self-clinching bearings into panels, with no need for precision-bored holes or machined mounts.

Also known as Oilite® bearings.

The oil in these bearings is suitable for incidental contact with food.

Use these bearings for frequent starts and stops in high-load applications. For low friction coefficients, they release a thin layer of an embedded PTFE lubricant during startup friction.

Made of FDA listed materials for use in food applications, these bearings also withstand caustic and washdown environments.

Made from slippery materials, these bearings reduce friction without the oily mess.

Made of acetal blended with PTFE, these bearings handle speeds twice as fast as standard sleeve bearings.

Embedded lubricant particles increase the load capacity of these bearings while also making them slippery.

Handling speeds twice as fast as standard mounted sleeve bearings while limiting wear on your system, these bearings are made of PTFE-filled acetal.

Mount these hubless bushings flush into your sprocket or pulley for a slim profile with no protruding screws.

Also known as Trantorque bushings, these tighten with a twist of the collar nut—no screws needed.

Keep these shaft collars in place by tightening their set screw into the shaft.

Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

These metal collars are stronger than plastic shaft collars.

Make quick adjustments to these shaft collars with a lever on the side.

Offering the benefits of a two-piece collar in a one-piece design, these collars swing open for positioning then close anywhere on your shaft.